Toyota Corolla 2004 Repair Manual - DOOR CONTROL TRANSMITTER
73–11
–THEFT DETERRENT & DOOR LOCK DOOR CONTROL TRANSMITTER
DOOR CONTROL TRANSMITTER
730B3–03
REGISTRATION
1. REGISTRATION OF RECOGNITION CODE
HINT:
The add mode is used to retain the already registered codes while registering a new recognition code.
This mode is used when adding a transmitter. If the number of the registered codes exceeds 4, the
previously registered code will be correspondingly erased in order, starting from the first registered
code.
The rewrite mode is used to erase all the previously registered codes and register only new recognition
codes. This mode is used when exchanging the transmitter or the door control receiver for new one.
The prohibition mode is used to erase all the registered codes and cancel the wireless door lock func-
tion. Use this mode when the transmitter is lost.
The confirmation mode is to confirm how many recognition codes have already been registered before
an additional registration of a recognition code.
All the following registration procedures must be performed in order continuously.
(a) The vehicle should be in the following conditions.
(1) The key is not inserted in the ignition key cylinder.
(2) Driver’s door is OPENED. (The other doors are CLOSED)
(3) Driver’s door is UNLOCKED.
(b) Perform the following operations to select the desired mode.
(1) Insert and remove the key from the ignition switch twice within 5 seconds.
(2) After the above operations, close and open the driver door twice within 40 seconds. Then insert
the key into the ignition key cylinder and remove it.
(3) After the above operations, close and open the driver door twice within 40 seconds. Then insert
the key into the ignition key cylinder and close the door.
(4) Turn the ignition switch from LOCK to ON and back to LOCK at approximately 1 second interval
1 to 5 times to select a mode (see the table below). Then remove the key from the ignition key
cylinder.
Number of ON–LOCK operation of ignition switch:
Add Mode
ON–LOCK operation: 1 time
T1
ON
LOCK
Rewrite Mode
ON–LOCK operation: 2 times
T1 T1
ON
LOCK
T1: Approx. 1 sec.
2004 COROLLA (RM1037U)
Confirmation Mode
ON–LOCK operation: 3 times
ON
LOCK
Prohibition Mode
ON–LOCK operation: 5 times
ON
LOCK
T1 T1
T1 T1
B58899
1803Author: Date:
73–12
–THEFT DETERRENT & DOOR LOCK DOOR CONTROL TRANSMITTER
NOTICE:
If the number of the ON–LOCK operation of the ignition switch is 0, 4 or 6 or more, there will be no
response (power door lock and unlock operation) to inform which mode has been selected.
(5) After selecting a mode, the integration relay automatically performs the power door
LOCK–UNLOCK operation within 3 seconds to inform the selected mode (see the table below).
HINT:
In the confirmation mode, when the operation is performed twice, it directs that 2 types of recognition
codes have been registered.
In the confirmation mode, If the number of the registration code is 0, the LOCK–UNLOCK operation
is automatically performed 5 times.
If the prohibition mode or confirmation mode is selected, registration procedure is completed.
Response of selected mode (Power door lock operation):
Confirmation ModeAdd Mode
LOCK
UNLOCK
LOCK
UNLOCK
T1: Approx. 1 sec.
T2: Approx. 2 sec.
T1
1st time
T2 T2
LOCK
UNLOCK
Prohibition ModeRewrite Mode
T1 T1 T1 T1
LOCK
UNLOCK
2nd time
(c) Register the new recognition codes (Add mode or Rewrite mode):
(1) Within 40 seconds after the add mode or the rewrite mode has been selected, press the LOCK
and UNLOCK switches on the transmitter switch simultaneously for 1.0 – 1.5 seconds.
Within 3 seconds after the previous operation, press either one of the switches for more than 1.0
seconds.
(2) Within 3 seconds after the transmitter switch has been turned OFF, the LOCK–UNLOCK opera-
tion will be automatically performed once if the registration of the recognition code of the transmitter is completed correctly .
In case the LOCK–UNLOCK operation is performed twice, the registra-
tion of recognition code has failed. Perform the registration procedure from the beginning once
again.
B50827
2004 COROLLA (RM1037U)
1804Author: Date:
Loading...