Toyota Corolla 2004 Repair Manual - FRONT SEAT

72–2

–SEAT FRONT SEAT

7209Y–01

OVERHAUL

CAUTION:
Wear the gloves, because the cutting surface of the seat back frame and seat adjuster may injure
your hand.

HINT:
Tape the screwdriver tip before use when prying parts.

1. DISCONNECT BATTERY NEGATIVE TERMINAL
CAUTION:
Wait for 90 seconds after disconnecting the battery terminal and disconnect the airbag connector.

2. REMOVE FRONT SEAT

(a) Remove the headrest.
(b) Remove the seat track covers and 4 bolts.
(c) Slide the seat to the most rear position.
(d) Disconnect the connector(s) under the seat.
(e) Remove the seat.

NOTICE:
Be careful not to damage the body.

3. REMOVE SEPARATE TYPE FRONT SEAT BACK ASSY

(a) Remove the bolt, washer and seat belt inner.

B58173

B58171

(b) Remove the seat cushion shield inner.

(c) Using a screwdriver, remove the reclining adjuster re-

lease handle.

(d) Remove the seat cushion shield outer.
(e) w/ side airbag:

Disconnect the airbag wire under the seat.

(f) Remove the hog rings, 4 bolts and seat back.

4. REMOVE SEPARATE TYPE FRONT SEAT BACK
COVER

(a) Remove the hog rings and turn up the seat back cover.

2004 COROLLA (RM1037U)

B58172

1786Author: Date:

–SEAT FRONT SEAT

(b) w/ side airbag:

Using a screwdriver, disconnect the clip.

(c) Remove the headrest supports, seat back cover and seat

back pad.

B57237

5. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER

(a) Remove the hog rings, seat cushion cover and seat cushion pad.

6. REMOVE FRONT SEAT ADJUSTER

(a) Remove the reclining adjuster inside covers.

7. INSTALL FRONT SEAT ADJUSTER

(a) Install the reclining adjuster inside covers.

8. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER

(a) Install the seat cushion pad to the seat adjuster.

72–3

B50126

B57311

(b) Using hog ring pliers, install the seat cushion cover with

new hog rings.

NOTICE:

 Be careful not to damage the cover.
 Be careful to prevent the cover wrinkles as little as

possible.

9. INSTALL SEPARATE TYPE FRONT SEAT BACK
COVER

(a) Install the seat back pad to the seat back spring assy.
(b) Cover the top of the seat back with the seat back cover.
(c) Install the headrest supports.

(d) w/ side airbag:

Connect the clip.

(e) Using hog ring pliers, fully install the seat back cover with

new hog rings.

NOTICE:

 Be careful not to damage the cover.
 Be careful to prevent the cover wrinkles as little as

possible.

10. INSTALL SEPARATE TYPE FRONT SEAT BACK ASSY

(a) Install the seat back with the 4 bolts.

Torque: 43 N⋅m (440 kgf⋅cm, 32 ft⋅lbf)

(b) Using hog ring pliers, install new hog rings.
(c) Install the cushion shield outer with the 2 screws.

2004 COROLLA (RM1037U)

1787Author: Date: