Toyota Corolla 2004 Repair Manual - FRONT NO.1 SPEAKER ASSY

AUDIO & VISUAL SYSTEM FRONT NO.1 SPEAKER ASSY
FRONT NO.1 SPEAKER ASSY
REPLACEMENT
HINT: COMPONENTS: See page 67–1
1. REMOVE FRONT ARMREST ASSY LH(See page 75–7)
2. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSY (W/ POWER WINDOW) (See page 75–7)
3. REMOVE FRONT ARMREST BASE PANEL UPPER LH (W/O POWER WINDOW) (See page 75–7)
4. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSY (W/O POWER WINDOW) (See page 75–7)
5. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH(See page 75–7)
6. REMOVE FRONT DOOR TRIM BOARD SUB–ASSY LH(See page 75–7)
7. REMOVE FRONT NO.1 SPEAKER ASSY
(a) Disconnect the connector. (b) Using a rivet cutter and air drill, drill out the rivets and re-
move the front No.1 speaker assy.
NOTICE:
Prizing the hole with a drill can lead to damage to the
rivet hole or breaking the drill.
Take care as the cut rivet is hot.
H15393
HINT: Even if flange is taken off, continue drilling and push out remain­ing fragments will the drill. (c) Using a vacuum cleaner, remove the drilled rivet and their
dust from the inside of the door.
67–5
670E0–01
1
3
Riveter
Mandrel
2
8. INSTALL FRONT NO.1 SPEAKER ASSY
(a) Using an air riveter and nose piece No.1, strike rivets into
the door panel to install the front No.1 speaker assy to the door panel.
NOTICE: Install them in the order shown in the illustration.
H15394
NOTICE:
Do not prize a riveter, as riveter is damaged, it is not
tightened and the mandrel is bent.
H02440
1717Author: Date:
67–6
Riveter
Riveter
Riveter
AUDIO & VISUAL SYSTEM FRONT NO.1 SPEAKER ASSY
Do not tilt the riveter and disconnect the rivet from the
material while handling a riveter, as the materials are not tightened firmly.
H02441
Install the rivet while attaching materials, as they are
not tightened firmily.
(b) Connect the connector.
H02442
9. INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSY (W/O POWER WINDOW) (See page 75–7)
1718Author: Date:
Loading...