Toyota Corolla 2004 Repair Manual - REAR SEAT BELT
61–15
–SEAT BELT REAR SEAT BELT
61087–02
REPLACEMENT
HINT:
Installation is in the reverse order of the removal. But the installation is indicated only when it has a point.
1. REMOVE REAR DOOR OPENING TRIM RH
2. REMOVE REAR DOOR OPENING TRIM LH
3. REMOVE REAR SEAT CUSHION ASSEMBLY (See page 72–6 or 72–8)
4. REMOVE REAR SEAT BACK ASSY (FIXED TYPE REAR SEAT) (See page 72–8)
5. REMOVE REAR SEAT BACK ASSY (SEPARATED TYPE REAR SEAT) (See page 72–6)
6. REMOVE REAR SEAT SIDE COVER RH (FIXED TYPE REAR SEAT) (See page 76–21)
7. REMOVE REAR SEAT SIDE GARNISH LH (FIXED TYPE REAR SEAT) (See page 76–21)
8. REMOVE ROOM PARTITION BOARD LH (SEPARATED TYPE REAR SEAT)
(See page 76–21)
9. REMOVE ROOM PARTITION BOARD RH (SEPARATED TYPE REAR SEAT)
(See page 76–21)
10. REMOVE ROOF SIDE GARNISH INNER RH (See page 76–21)
11. REMOVE ROOF SIDE GARNISH INNER LH (See page 76–21)
12. REMOVE PACKAGE TRAY TRIM PANEL ASSY
(a) Pull out the belt from the slit, and then remove the pack-
age tray trim panel assembly.
B59276
13. REMOVE REAR SEAT 3 POINT TYPE BELT ASSY OUTER
(a) Remove the bolt and disconnect the rear seat 3 point type belt assembly outer (floor anchor).
(b) Remove the bolt and rear seat 3 point type belt assembly outer.
14. REMOVE REAR SEAT INNER W/CENTER BELT ASSY RH
(a) Remove the 2 bolts and rear seat inner w/ center belt assembly RH.
15. REMOVE REAR SEAT INNER W/CENTER BELT ASSY LH
(a) Remove the bolt and rear seat inner w/ center belt assembly LH.
16. REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET SUB–ASSY RH
(a) Remove the 2 bolts and child restraint seat anchor bracket RH.
17. INSTALL CHILD RESTRAINT SEAT ANCHOR BRACKET SUB–ASSY RH
(a) Install the child restraint seat anchor bracket RH with the 2 bolts.
Torque: 18.1 N⋅m (185 kgf⋅cm, 13.3 ft⋅lbf)
2004 COROLLA (RM1037U)
1675Author: Date:
61–16
–SEAT B E LT REAR SEAT BELT
Front
Protrusion Part
Protrusion Part
Unlock
Lock
Front
Mark
45
B58711
B50564
18. INSTALL REAR SEAT INNER W/CENTER BELT ASSY
LH
(a) Install the rear seat inner w/ center belt assembly RH with
the bolt, as shown in the illustration.
Torque: 41.2 N⋅m (420 kgf⋅cm, 30 ft⋅lbf)
NOTICE:
Do not make the anchor part run onto the protrusion
part of the floor panel.
Do not disassemble the retractor.
(b) Check the degree of tilt when the belt begins to lock the
ELR.
(1) Check that the belt will not lock within 15 degrees of
tilt in all the direction but the belt will lock over 45 degrees of tilt when moving the installed retractor
gently.
If the operation is not as specified, replace the rear seat belt assembly outer center.
(c) Install the rear seat belt assembly outer center with the
bolt.
Torque: 41.2 N⋅m (420 kgf⋅cm, 30 ft⋅lbf)
(d) Check the ELR lock.
NOTICE:
Check should be performed with the assembly installed.
(1) Check that the belt will lock when pulling out the belt
quickly with the belt installed.
If the operation is not as specified, replace the rear seat belt assembly outer center.
(e) Check the fastening function of the child restraint system.
NOTICE:
Check should be performed with the assembly installed.
(1) Check that the belt cannot be pulled out any more
but can be rewound after the belt is fully pulled out.
(2) Check that the belt can be pulled out and rewound
after the belt is fully rewound.
If the operation is not as specified, replace the rear seat belt assembly outer center.
Protrusion Part
Front
Protrusion Part
2004 COROLLA (RM1037U)
Front
Mark
19. INSTALL REAR SEAT INNER W/CENTER BELT ASSY
RH
(a) Install the rear seat inner w/ center belt assembly RH with
the bolt, as shown in the illustration.
Torque: 41.2 N⋅m (420 kgf⋅cm, 30 ft⋅lbf)
NOTICE:
Do not make the anchor part run onto the protrusion part
of the floor panel.
B59304
1676Author: Date:
Loading...