Toyota Corolla 2004 Repair Manual - FRONT SEAT BELT

61–9

–SEAT BELT FRONT SEAT BELT

6108A–02

DISPOSAL

HINT:
When scrapping vehicles epuipped with a seat belt pretensioner or disposing of a front seat outer belt (with
seat belt pretensioner) always first active the seat belt pretensioner in accordance with the procedure de­scribed below. If any abnormality occurs in the seat belt pretensioner operation, contact the SERVICE DEPT.
of the TOYOT A M O TOR SA L E S , U .S.A., INC. When disposing of a front seat outer belt (with seat belt preten­sioner) activated in a collision, follow the same procedure givenin step 1–(e) in ”DISPOSAL”.

CAUTION:

 Never dispose of front seat outer belt which has an in-

activated pretensioner.

SST

B50515

 The seat belt pretensioner produces a sizeable ex-

ploding sound when it activates, so perform the op­eration out–of–door and where it will not create a nui­sance to nearby residents.

 When activating a front seat outer belt (with seat belt

pretensioner), perform the operation at least 10 m (33
ft) away from the front seat outer belt.

 Use gloves and safety glasses when handling a front

seat belt with activated pretensioner.

 Always wash your hands with water after completing

the operation.

 Do not apply water, etc. to a front seat outer belt with

activated pretensioner.

 When activating the seat belt pretensioner, always

use the specified SST. (SRS Airbag Deployment T ool)
Perform the operation in a place away from electrical
noise.

SST 09082–00700

2004 COROLLA (RM1037U)

1. DISPOSE OF FRONT SEAT OUTER BELT ASSY RH
(WHEN INSTALLED WITH VEHICLE)

HINT:
Check that the battery positive voltage is above 12 V.

B50511

1669Author: Date:

61–10

SST

SST

Battery

–SEAT B E LT FRONT SEAT BELT

(a) Check the functioning of SST.

CAUTION:
When activating the seat belt pretensioner, always use a
specified SST.

SST 09082–00700, 09082–00770

B50515

(1) Connect the SST to the battery.

Connect the red clip of the SST to the battery posi­tive (+) terminal and the black clip to the battery neg-

ative (–) terminal.
HINT:
Do not connect the yellow connector which will be connected
to the seat belt pretensioner.

B50511

(2) Check the functioning of SST.

Press the SST activation switch, and check that the

SST

LED of the SST activation switch lights up.

CAUTION:
If the LED lights up when the activation switch is not
pressed, the SST probably malfunctions, so definitely do
not use the SST.

B50514

(b) Disconnect the SST from the battery.
(c) Disconnect the pretensioner connector.

(1) Disconnect the battery negative terminal.
(2) Check the SRS airbag system (See page 60–1).
(3) Remove the front door scuff plate RH (See page 76–21).
(4) Remove the rear door scuff plate RH (See page 76–21).
(5) Remove the front door opening trim RH.
(6) Remove the rear door opening trim RH.
(7) Remove center pillar garnish lower RH (See page 76–21).

B50195

2004 COROLLA (RM1037U)

(8) Disconnect the pretensioner connector as shown in

the illustration.
(d) Install the SST.

(1) Install the floor anchor of the seat belt.

B57295

1670Author: Date: