Toyota Corolla 2004 Repair Manual - SIDE AIR BAG SENSOR ASSY RH

60–44

–SUPPLEMENTAL RESTRAINT SYSTEM SIDE AIR BAG SENSOR ASSY RH

REPLACEMENT

HINT:
COMPONENTS: See page 60–43

1. PRECAUTION (See page 60–1)

2. DISCONNECT BATTERY NEGATIVE TERMINAL (See page 60–1 )

3. REMOVE FRONT DOOR SCUFF PLATE RH (See page 76–21)

4. REMOVE REAR DOOR SCUFF PLATE RH (See page 76–21)

5. REMOVE FRONT DOOR OPENING TRIM RH (See page 76–21)

6. REMOVE REAR DOOR OPENING TRIM RH (See page 76–21)

7. REMOVE LAP BELT OUTER ANCHOR COVER (See page 76–21)

8. REMOVE CENTER PILLAR GARNISH LOWER RH (See page 76–21)

9. REMOVE FRONT SEAT OUTER BELT ASSY RH (See page 61–7)

10. REMOVE SIDE AIR BAG SENSOR ASSY RH

(a) Disconnect the connector from the side airbag sensor

assy RH.

(b) Remove the 2 nuts and side airbag sensor assy RH.

6007X–03

H42054

11. INSPECT SIDE AIR BAG SENSOR ASSY RH (See page 60–8)

12. INSTALL SIDE AIR BAG SENSOR ASSY RH

(a) Install the 2 nuts and side airbag sensor assy RH.

Torque: 8.0 N⋅m (82 kgf⋅cm, 71 in⋅lbf)

(b) Connect the side airbag sensor connector.

NOTICE:

 Installation of the connector is done with the sensor assembly installed. Make sure that the sen-

sor assembly is installed to the specified torque.

 If the sensor assembly has been dropped, or there are cracks, dents or other defects in the

case, bracket or connector, replace the sensor assembly with a new one.

 When installing the sensor assembly , take care that the SRS wiring does not interfere with other

parts and is not pinched between other parts.

 After installation, shake the sensor assembly to check that there is no looseness.

13. INSTALL FRONT SEAT OUTER BELT ASSY RH
Torque:
Upper bolt: 4.9 N⋅m (50 kgf⋅cm, 43 in.⋅lbf)
Lower bolt: 41.2 N⋅m (420 kgf⋅cm, 30 ft⋅lbf)

14. INSPECT SRS WARNING LIGHT (See page 05–424 )

2004 COROLLA (RM1037U)

1658Author: Date: