Toyota Corolla 2004 Repair Manual - SEAT POSITION AIR BAG SENSOR

60–46

–SUPPLEMENTAL RESTRAINT SYSTEM SEAT POSITION AIR BAG SENSOR

REPLACEMENT

HINT:
COMPONENTS: See page 60–45

1. PRECAUTION (See page 60–1)

2. DISCONNECT BATTERY NEGATIVE TERMINAL (See page 60–1 )

3. REMOVE SEAT TRACK UPPER RAIL COVER RH

4. REMOVE SEAT TRACK UPPER RAIL COVER LH

5. REMOVE FRONT SEAT ASSY LH (See page 72–2)

6. REMOVE SEAT POSITION AIR BAG SENSOR

(a) Disconnect the connector of the seat position airbag sen-

sor.

(b) Using a torx socket wrench (T30), remove the torx screw

and seat position airbag sensor.

H41697

60081–04

7. INSTALL SEAT POSITION AIR BAG SENSOR

(a) Using a torx socket wrench (T30), install the seat position airbag sensor with the torx screw.

Torque: 8.0 N⋅m (82 kgf⋅cm, 71 in.⋅lbf)

(b) Connect the connector of the seat position airbag sensor.

NOTICE:

 Installation of the connector is done with the seat position airbag sensor installed. Make sure

the seat position airbag sensor is installed to the specified torque.

 If the seat position airbag sensor has been dropped, or there are cracks, dents or other defects

in the case, bracket or connector, replace the seat position airbag sensor with a new one.

 When installing the seat position airbag sensor, take care that the SRS wiring does not interfere

with other parts and is not pinched between other parts.

 After installation, shake the seat position airbag sensor to check that there is no looseness.

8. INSTALL FRONT SEAT ASSY LH

Torque: 47.1 N⋅m (480 kgf⋅cm, 35 ft⋅lbf)

9. INSPECT SRS WARNING LIGHT (See page 05–424)

2004 COROLLA (RM1037U)

1660Author: Date: