Toyota Corolla 2004 Repair Manual - W/RECEIVER CONDENSER ASSY
–HEATER & AIR CONDITIONER W/RECEIVER CONDENSER ASSY
OVERHAUL
HINT:
COMPONENTS: See page 55–40
1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM (See page 55–11)
SST 07110–58060 (07117–58080, 07117–58090, 07117–78050, 07117–88060, 07117–88070,
07117–88080)
2. DISCONNECT COOLER REFRIGERANT LIQUID PIPE
A
(a) Remove the bolt and disconnect the cooler refrigerant liq-
uid pipe A from the w/receiver condenser assy.
(b) Remove the O–ring from the cooler refrigerant liquid pipe
A.
NOTICE:
Seal the opening of the disconnected parts using vinyl tape
I31967
to prevent moisture and foreign matter from entering.
55–41
550IY–01
I32450
I32451
3. DISCONNECT DISCHARGE HOSE SUB–ASSY
(a) Remove the bolt and discharge hose sub–assy from the
w/receiver condenser assy.
(b) Remove the O–ring from the discharge hose sub–assy.
NOTICE:
Seal the opening of the disconnected parts using vinyl tape
to prevent moisture and foreign matter from entering.
4. REMOVE W/RECEIVER CONDENSER ASSY
(a) Remove the 2 bolts and 2 radiator upper supports.
(b) Remove the 2 bolts.
(c) Slide the upper part of the radiator assy rearward to re-
move the w/receiver condenser assy.
2004 COROLLA (RM1037U)
I32452
1611Author: Date:
55–42
14 mm
(0.55 in.)
Hexagon
Wrench
–HEATER & AIR CONDITIONER W/RECEIVER CONDENSER ASSY
5. REMOVE COOLER DRYER
(a) Using a socket hexagon wrench 14 mm (0.55 in.), remove
the cap from the modulator.
Modulator
I30086
(b) Remove the O–ring from the cap.
E55408
I32475
(c) Using pliers, remove the cooler dryer.
6. INSTALL COOLER DRYER
(a) Using pliers, install the cooler dryer.
E50386
(b) Install the new O–ring to the cap.
(c) Sufficiently apply compressor oil to the fit surfaces of the
O–ring and the cap.
Compressor oil: ND–OIL 8 or equivalent
E55408
14 mm
(0.55 in.)
Hexagon
Wrench
2004 COROLLA (RM1037U)
(d) Using a socket hexagon wrench 14 mm (0.55 in.), install
the cap to the modulator.
Torque: 2.9 N⋅m (29 kgf⋅cm, 25 in.⋅lbf)
Modulator
I30086
1612Author: Date:
Loading...