Toyota Corolla 2004 Repair Manual - HEATER CONTROL ACCESSORY ASSY
–HEATER & AIR CONDITIONER HEATER CONTROL & ACCESSOR Y ASSY
HEATER CONTROL & ACCESSORY ASSY
REPLACEMENT
1. REMOVE CONSOLE PANEL UPPER (See page 71–10)
2. REMOVE INSTRUMENT CLUSTER FINISH PANEL (See page 71–10)
3. REMOVE HEATER CONTROL & ACCESSORY ASSY
(a) Release the 2 fitting claws and pull out the heater control
& accessory assy.
55–13
550IT–01
2 Claws
I32427
I32428
I32429
I32430
(b) Using a screwdriver, open the claw of the cable clamp and
disconnect the defroster damper control cable.
NOTICE:
Be careful not to bend the cable wire.
If the cable wire bends, the heater control & accesso-
ry assy operationality becomes worse.
HINT:
Tape the screwdriver tip before use.
(c) Using a screwdriver , open the claw of the cable clamp and
disconnect the air mix damper control cable.
NOTICE:
Be careful not to bend the cable wire.
If the cable wire bends, the heater control & accesso-
ry assy operationality becomes worse.
HINT:
Tape the screwdriver tip before use.
(d) Disconnect the connector, remove the heater control &
accessory assy.
4. INSTALL HEATER CONTROL & ACCESSORY ASSY
(a) Install the inner cable end of the air mix damper control
cable to the heater control lever.
(b) Install the outer cable of the air mix damper control cable
to the cable clamp.
NOTICE:
Be careful not to bend the cable wire.
If the cable wire bends, the heater control & accesso-
ry assy operationality becomes worse.
2004 COROLLA (RM1037U)
1583Author: Date:
55–14
I32431
–HEATER & AIR CONDITIONER HEATER CONTROL & ACCESSOR Y ASSY
HINT:
Operating the heater control knob and check that it prop-
erly stops at both ends of MAX. COOL and MAX. HOT
and no recoil is identified.
Check that the outer cable should not be disengaged
(moved) from the heater control & accessory assy when
the cable is pulled.
(c) Install the inner cable end of the defroster damper control
cable to the heater control lever.
(d) Install the outer cable of the defroster damper control
cable to the cable clamp.
NOTICE:
Be careful not to bend the cable wire.
If the cable wire bends, the heater control & accesso-
ry assy operationality becomes worse.
HINT:
Operating the heater control knob and check that it prop-
erly stops at both ends of F ACE and DEF and no recoil is
identified.
Check that the outer cable should not be disengaged
(moved) from the heater control & accessory assy when
the cable is pulled.
(e) Connect the connector, install the heater control & acces-
sory assy.
2004 COROLLA (RM1037U)
1584Author: Date:
Loading...