Toyota Corolla 2004 Repair Manual - FLOOR SHIFT CABLE TRANSMISSION CONTROL SHIFT

–AUTOMA TIC TRANSMISSION / TRANS FLOOR SHIFT CABLE TRANSMISSION CONTROL

SHIFT (ATM)

FLOOR SHIFT CABLE TRANSMISSION CONTROL
SHIFT (ATM)

REPLACEMENT

1. PRECAUTION (See page 60–1 )

2. DISCONNECT BATTERY NEGATIVE TERMINAL

3. REMOVE PARKING BRAKE HOLE COVER SUB–ASSY (See page 71–10)

4. REMOVE CONSOLE PANEL UPPER (See page 71–10)

5. REMOVE CONSOLE BOX CARPET (See page 71–10)

6. REMOVE CONSOLE BOX SUB–ASSY REAR (See page 71–10)

7. REMOVE AIR BAG SENSOR ASSY CENTER (See page 60–38)

8. DISCONNECT OXYGEN SENSOR CONNECTOR

(a) Remove the foot rest.
(b) Pull up the floor carpet.
(c) Disconnect the oxygen sensor connector.

9. REMOVE FLOOR PANEL BRACE FRONT

(a) Remove the 2 nuts and floor panel brace.

10. REMOVE EXHAUST PIPE ASSY FRONT (See page 15–2)

11. REMOVE FRONT FLOOR HEAT INSULATOR NO.1

(a) Remove the 3 nuts and heat insulator.

12. REMOVE AIR CLEANER CASE

13. REMOVE AIR CLEANER HOSE NO.1

40–45

400LT–01

C96147

C80196

14. REMOVE FLOOR SHIFT CABLE TRANSMISSION
CONTROL SHIFT

(a) Remove the nut from control shaft lever.
(b) Disconnect the control cable from the control shaft lever.
(c) Remove the clip and disconnect the control cable from

the control cable bracket.

(d) Disconnect the control cable from the control cable sup-

port.

(e) Remove the 2 nuts.

2004 COROLLA (RM1037U)

1395Author: Date:

40–46

C93669

–AUTOMATIC TRANSMISSION / TRANS FLOOR SHIFT CABLE TRANSMISSION CONTROL

SHIFT (ATM)

(f) Remove the cable end from the rod of the floor shift as-

sembly.

(g) Using a screw driver, disconnect the control cable from

the shift lever plate.

C94276

C80197

C80197

(h) Remove the 2 bolts.
(i) Pull out the control cable assy from the body.
(j) Remove the retainer from the shift cable.

15. INSTALL FLOOR SHIFT CABLE TRANSMISSION
CONTROL SHIFT

(a) Install the retainer to the shift cable.
(b) Pull in the control cable assy to the body.
(c) Install the 2 bolts.

Torque: 5.0 N⋅m (50 kgf⋅cm, 43 in.⋅lbf)

2004 COROLLA (RM1037U)

(d) Install the control cable to the shift lever plate.

C94297

1396Author: Date: