Toyota Corolla 2004 Repair Manual - PARKING BRAKE CABLE ASSY NO.3

33–10

–PARKING BRAKE PARKING BRAKE CABLE ASSY NO.3

33018–03

REPLACEMENT

HINT:
For parking brake cable assy No.2, perform the same procedure to the parking brake cable assy No.3.

1. REMOVE REAR WHEEL

2. REMOVE REAR BRAKE DRUM SUB–ASSY (See page 32–31)

3. REMOVE REAR BRAKE AUTOMATIC ADJUST LEVER LH (See page 32–31)

4. REMOVE FRONT BRAKE SHOE (See page 32–31)

SST 09718–00010

5. REMOVE PARKING BRAKE SHOE STRUT SET LH (See page 32–31)

6. REMOVE REAR BRAKE SHOE (See page 32–31)

SST 09718–00010

7. DISCONNECT PARKING BRAKE CABLE ASSY NO.3

(a) Remove the bolt, and disconnect the parking brake cable

assy No.3 from the backing plate.

F42652

8. REMOVE EXHAUST PIPE ASSY FRONT (See page 15–2)

9. REMOVE FRONT FLOOR HEAT INSULATOR NO.1 (See page 33–7)

10. REMOVE FRONT FLOOR HEAT INSULATOR NO.2 (See page 33–7)

11. REMOVE FUEL TANK PROTECTOR NO.1

(a) Remove the 5 nuts and fuel tank protector No.1.

12. REMOVE PARKING BRAKE CABLE ASSY NO.3

(a) Using a clip remover, disconnect the skid control sensor

wire harness clip from the clamp.
(b) Remove the 4 bolts and cable retainer from the body.
(c) Disconnect the parking brake cable assy No.3 from the

equalizer, and remove the parking brake cable assy No.3.

13. INSTALL PARKING BRAKE CABLE ASSY NO.3

(a) Connect the parking brake cable assy No.3 to the equaliz-

F42653

er.

2004 COROLLA (RM1037U)

1348Author: Date:

33–11

–PARKING BRAKE PARKING BRAKE CABLE ASSY NO.3

(b) Install the parking brake cable assy No.3 with the 4 bolts

and cable retainer.

Torque: 5.4 N⋅m (55 kgf⋅cm, 48 in.⋅lbf)

(c) Connect the skid control sensor wire harness clip to the

clamp.

14. INSTALL FUEL TANK PROTECTOR NO.1

(a) Install the fuel tank protector No.1 with the 5 nuts.

Torque: 5.5 N⋅m (55 kgf⋅cm, 48 in.⋅lbf)

F42653

15. INSTALL FRONT FLOOR HEAT INSULATOR NO.2 (See page 33–7)

16. INSTALL FRONT FLOOR HEAT INSULATOR NO.1 (See page 33–7)

17. INSTALL EXHAUST PIPE ASSY FRONT (See page 15–2)

18. CONNECT PARKING BRAKE CABLE ASSY NO.3

(a) Connect the parking brake cable assy No.3 to the backing

plate with the bolt.

Torque: 7.8 N⋅m (80 kgf⋅cm, 69 in.⋅lbf)

F42654

2004 COROLLA (RM1037U)

F42652

1349Author: Date: