32–44
–BRAKE SPEED SENSOR FRONT LH
SPEED SENSOR FRONT LH
REPLACEMENT
HINT:
Replace the RH side by the same procedure as the LH side.
1. REMOVE FRONT WHEEL
2. REMOVE FRONT FENDER LINER LH
3. REMOVE SPEED SENSOR FRONT LH
(a) Disconnect the speed sensor wire harness clamp from
the body.
(b) Disconnect the speed sensor connector.
320IQ–02
F42599
F40024
C80815
(c) Remove the 2 clamp bolts holding the sensor harness
from the body and shock absorber.
(d) Remove the bolt and speed sensor front LH.
NOTICE:
Keep on the sensor tip clean.
2004 COROLLA (RM1037U)
4. INSTALL SPEED SENSOR FRONT LH
(a) Install the speed sensor front LH with the bolt.
Torque: 8.0 N⋅m (82 kgf⋅cm, 71 in.⋅lbf)
NOTICE:
Make sure the sensor tip is clean.
C80815
1335Author: Date:
32–45
–BRAKE SPEED SENSOR FRONT LH
(b) Install the sensor harness clamp with the 2 bolts ”A” and
”B” to the body and shock absorber.
A
Torque:
Bolt A: 8.0 N⋅m (82 kgf⋅cm, 71 in.⋅lbf)
Bolt B: 29 N⋅m (296 kgf⋅cm, 21 ft⋅lbf)
B
F40024
(c) Connect the speed sensor connector.
(d) Connect the speed sensor wire harness clamp to the
body.
F42599
5. INSTALL FRONT FENDER LINER LH
6. INSTALL FRONT WHEEL
Torque: 103 N⋅m (1,050 kgf⋅cm, 76 ft⋅lbf)
7. CHECK ABS SPEED SENSOR SIGNAL (See page 05–297 )
2004 COROLLA (RM1037U)
1336Author: Date: