Toyota Corolla 2004 Repair Manual - REAR AXLE HUB BEARING ASSY LH

30–24

–DRIVE SHAFT / PROPELLER SHAFT REAR AXLE HUB & BEARING ASSY LH

REPLACEMENT

HINT:
COMPONENTS: See page 30–23

1. REMOVE REAR WHEEL

2. REMOVE REAR BRAKE DRUM SUB–ASSY

3. DISCONNECT SKID CONTROL SENSOR WIRE (W/ ABS)

4. REMOVE REAR AXLE HUB & BEARING ASSY LH

(a) Remove the 4 bolts and hub & bearing assy LH.

300A7–03

C66800

5. INSTALL REAR AXLE HUB & BEARING ASSY LH

(a) Install the hub & bearing assy LH with the 4 bolts.

Torque: 61 N⋅m (622 kgf⋅cm, 45 ft⋅lbf)

C66800

6. CONNECT SKID CONTROL SENSOR WIRE (W/ ABS)

7. INSPECT BEARING BACKLASH

(a) Set a dial indicator near the center of the axle hub and

check the backlash in the bearing shaft sirection.

Maximum: 0.05 mm (0.0020 in.)

If the backlash exceeds the maximum, replace the rear axle hub
& bearing assy LH.

2004 COROLLA (RM1037U)

D26921

1289Author: Date:

–DRIVE SHAFT / PROPELLER SHAFT REAR AXLE HUB & BEARING ASSY LH

8. INSPECT AXLE HUB DEVIATION

(a) Using a dial indicator, check the deviation at the surface

of the axle hub outside the hub bolt.

Maximum: 0.07 mm (0.0028 in.)

If the backlash exceeds the maximum, replace the rear axle hub
& bearing assy LH.

D26922

9. INSTALL REAR BRAKE DRUM SUB–ASSY

10. INSTALL REAR WHEEL

Torque: 103 N⋅m (1,050 kgf⋅cm, 76 ft⋅lbf)

11. CHECK ABS SPEED SENSOR SIGNAL (W/ ABS) (See page 05–297 )

30–25

2004 COROLLA (RM1037U)

1290Author: Date: