27–8
–REAR SUSPENSION REAR AXLE BEAM ASSY
REAR AXLE BEAM ASSY
REPLACEMENT
HINT:
COMPONENTS: See page 27–2
1. REMOVE REAR WHEEL
(a) Remove the RH and LH rear wheels.
2. REMOVE REAR BRAKE DRUM SUB–ASSY(See page 32–31)
3. SEPARATE SKID CONTROL SENSOR WIRE
(a) Disconnect the skid control sensor connector.
(b) Remove the 2 bolts and separate the wire harness
clamps.
(c) Remove the bolt and separate parking brake cable
clamp.
(d) Using the same manner desoribed above to the other
side.
C68929
2707S–02
4. REMOVE STABILIZER BAR REAR(See page 27–13)
5. REMOVE REAR AXLE HUB & BEARING ASSY LH
(a) Remove the 4 bolts and rear axle hub from the axle beam.
C66800
6. REMOVE REAR AXLE HUB & BEARING ASSY RH
HINT:
Remove the RH side by the same procedures with the LH side.
7. SEPARATE REAR SHOCK ABSORBER WITH COIL
SPRING
(a) Remove the nut, washer and separate the rear shock ab-
sorber w/coil spring (lower side) from the rear axle beam.
(b) Using the same manner desoribed above to the other
side.
2004 COROLLA (RM1037U)
C67565
1259Author: Date:
Wood
Block
27–9
–REAR SUSPENSION REAR AXLE BEAM ASSY
8. REMOVE REAR AXLE BEAM ASSY
(a) Support the rear axle beam with jack.
C66806
(b) Remove the 2 bolts, nuts and rear axle beam.
Notch
Notch
Matchmarks
SST
Bend Portions
C81494
9. REMOVE REAR AXLE CARRIER BUSH LH
(a) Place matchmarks on the 2 notches of the bushing and
axle beam.
(b) Using a chisel and a hammer, bend the 2 portions of the
bushing rib.
HINT:
Bend the bushing rib until the claw of SST can be hung.
(c) Using SST, remove the bushing from the axle beam.
SST 09950–40011 (09951–04020, 09952–04010,
09953–04030, 09954–04020, 09955–04051,
09957–04010, 09958–04011), 09950–60010
(09951–00630)
NOTICE:
If the axle beam has been scratched, apply the paint.
F40275
10. REMOVE REAR AXLE CARRIER BUSH RH
HINT:
Remove the RH side by the same procedures with the LH side.
SST 09950–40011 (09951–04020, 09952–04010, 09953–04030, 09954–04020, 09955–04051,
09957–04010, 09958–04011), 09950–60010 (09951–00630)
2004 COROLLA (RM1037U)
1260Author: Date: