Toyota Corolla 2004 Repair Manual - OIL FILTER SUB–ASSY

17–10
LUBRICATION OIL FILTER SUB–ASSY
1707K–01
REPLACEMENT
CAUTION:
Prolonged and repeated contact with mineral oil will result in the removal of natural fats from
the skin, leading to dryness, irritation and dermatitis. In addition, used engine oil contains po­tentially harmful contaminants which may cause skin cancer.
Exercise caution in order to minimize the length and frequency of contact of your skin to used
oil. Wear protective clothing and gloves. Wash your skin thoroughly with soap and water, o r u s e water–less hand cleaner to remove any used engine oil. Do not use gasoline, thinners, or sol­vents.
In order to preserve the environment, used oil and used oil filter must be disposed of only at
designated disposal sites.
1. REMOVE ENGINE UNDER COVER RH
2. DRAIN ENGINE OIL
(a) Remove the oil pan drain plug and drain the engine oil.
3/4 turn
3. REMOVE OIL FILTER SUB–ASSY
(a) Using SST, remove the oil filter
SST 09228–06501
SST
B00182
4. INSTALL OIL FILTER SUB–ASSY
(a) Check and clean the oil filter installation surface. (b) Apply clean engine oil to the gasket of a new oil filter.
(c) Lightly screw the oil filter into place, and tighten it until the
gasket contacts the seat.
(d) Using SST, tighten it an additional 3/4 turn.
SST 09228–06501
A65962
5. INSTALL OIL PAN DRAIN PLUG
(a) Clean and install the oil pan drain plug with a new gasket.
Torque: 37 Nm (377 kgf⋅cm,
2004 COROLLA (RM1037U)
27 in.⋅lbf)
1205Author: Date:
LUBRICATION OIL FILTER SUB–ASSY
6. ADD ENGINE OIL Capacity: Drain and refill w/ Oil filter change 3.7 liters (3.9 US qts, 3.3 lmp. qts) Drain and refill w/o Oil filter change 3.5 liters (3.7 US qts, 3.1 lmp. qts) Dry fill 4.2 liters (4.4 US qts, 3.7 lmp. qts)
7. INSPECT OIL LEAK
17–11
2004 COROLLA (RM1037U)
1206Author: Date:
Loading...