TOYO ELECTRIC MFG TY S 001 1 User Manual

Operating Instructions For Bluetooth Speaker

There are two ways to play music through the blue tooth speaker – SD Card or through your portable device

1. To play through your SD Card

1) Make sure the bluetooth speaker is plugged and push mode button until a red light appears on top of
the speaker.

2) SD Card – plug your SD card into the backside of the speaker.
** note** The SD Card must be pre-loaded with the music you desire to play.

** Note**

Under SD mode, You can increase the volume FURTHER by using the volume buttons on the top
of the speaker (as shown below). Make sure you hold down the volume button in order to adjust the volume
setting (long press)

The music on the SD card can also be controlled through the buttons on top of the speaker as shown below.
Use “short press” to activate this.

Pause/play

Switch between
SD Card and
Blue tooth mode

Power ON/OFF

REVERSE – to previous song

FAST FORWARD – to next song

2. TO PLAY THROUGH YOUR WIRELESS DEVICE:

1) Make sure the bluetooth speaker is plugged in and push mode button until a blue light appears on top of the

speaker.

2) Make sure the blue-tooth name “ Glo-TEC” is highlighted on your device.

3) Ensure the bluetooth setting is activated on your device and paired with the speaker before playing music.

4) After you select your music and it begins playing through the blue tooth speaker.

5) you can adjust the volume of the blue tooth speaker by increasing the volume on your wireless device. You can

also increase the volume FURTHER by using the volume buttons on the top of the speaker. Make sure you
hold down the volume button in order to adjust the volume setting (long press)