TownSteel CEM User Manual

TS Standalone Cylindrical Lock

e-Elite 4000

Index

Definitions······································································2
Factory Default Settings··················································· 2
Important Notes ····························································· 3
Change Master Code······················································· 4
Add Credentials······························································ 4

Add a User Code
Add Multiple User Codes
Add User Keycards

Delete Credentials··························································· 6

Delete User Code
Delete User Keycard
Reset to Factory Default Settings

System Settings ····························································· 7

Passage Mode
Verification Mode

Sound
Reset to Factory Default Settings w/o Master Code··············· 8
Low Battery ·································································· 8

CEM-190327-0496 1

Definitions

 Credential: The lock requires a valid credential to operate. A credential can be a Master Code, User Code, or

Keycard/Fob.

 LED Indicator: The LED indicators are located around the keypad of the lock. Lock flashes green LED and/or red LED

dependent on inputs. While unlocking, a red LED followed by a green LED means the lock is not programmed and can

be unlocked with any 6-10 digit code or Keycard/Fobs.

 i

 Master Code: The Master Code programs all User Codes, Keycards/Fobs (Credentials), and System Settings. The

Factory Default Setting’s Master Code is 123456. This must be changed before programming the lock. Each lock has

one Master Code. Master Code cannot be deleted.

 i



User Code: User Codes are used to operate the lock. User Codes are programmed by the Master Code. The lock can

have a maximum of 447 User Codes (interchangeable with Keycards/Fobs).

i



 User Keycard/Fob: Keycards or Fobs can be used to operate the lock. Master Code is used to program User

Keycards/Fobs. Swipe the touch keypad with a Keycard/Fob to operate the lock. The lock can have a maximum of 447

Keycards/Fobs (interchangeable with User Codes). Any standard Keycard/Fob can be programmed into the lock.

i



 Passage Mode: Door will remain actively unlocked until the Master Code or the Passage Credential is re-entered.

 i

 Dual Verification Mode: Two valid credentials are needed to unlock the door.

 i

 Sound: Keypad sound is enabled by Factory Default Settings. Disabling the sound only affects general operation, not

during programming of the lock. During programming mode, lock will temporarily re-enable sound.

Factory Default Settings

Master Code: 123456
Penalty Time: 1 minute 30 seconds after 5 invalid entries
Passage Mode: Disabled
Dual Verification Mode: Disabled
Sound: Enabled

CEM-190327-0496 2