Town & Country Fireplaces TCWS.38CE2, TCWS.38NG04C2 Instructions For The Use

INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.

These instructions are supplementary to the Installation
and Operating Instructions supplied with the  replace
and should be kept together. Refer to the Installation
and Operating Instructions for proper gas supply, safety
requirements and operating instructions.

TRANQUILITY
BURNER KIT
INSTRUCTIONS

240910-16 5056.425234 TCWS.38NG04C2

PART# TCWS.38NG04C2

For use with
Model TCWS.38CE2
Series C

Contents of Package

D

E

A

B

C

D

E

F

A

B

F

1 5.0 LBS SAND

1 HARDWARE PACK

1 EQUALIZER ROCK

2 BURNER ASSEMBLIES

1 BURNER TRAY ASSEMBLY

3 PEBBLE SETS

F

C

F

TCWS.38NG04C2 240910-16

2

Tranquility Burner Installation

Fig #1

Fig #2

If converting to propane see conver­sion instructions on page #7 before
proceeding.

Install panels according to the
TCWS.38CE2 Installation and
Operating manual prior to burner
installation. (Page 26)

1. Install the right burner by tipping into
location trough and slipping the venturi
tube over the ori ce. Test for
connection by lifting at a location pin
on the right side of the burner. Repeat
with left burner. (Fig. #1)

NOTE: check air shutter for correct
fuel setting before proceeding
further. Both burners are the same.
Fully closed for natural gas.
1/8” (0.125)” open for LP.

CAUTION: The burners should be tightly
butted up against each other at the center
to ensure correct operation.

Fig #3

2. Tilt burner tray length-wise and insert
into the  rebox.
(Fig. #2)

3. Attach pilot to burner tray. (2 screws)
(Fig. #3)

TCWS.38NG04C2 240910-16

3

4. Secure the burner tray to legs using
six screws (Fig. #4)

NOTE: a light will aid aligning the holes
in the tray with the leg

Fig #4

Fig #5

5. Place sand into the burner tray and
brush smooth. Use caution not to get
sand near the burner ports. (Fig. #5)

TCWS.38NG04C2 240910-16

4

6. Each rock has a slot in it’s base and is
marked with a letter and an arrow.
(Fig. #6)

Fig #6

Fig #10

7. Place each rock as per the following
photographs, start from the right hand
side of the burner and ensure that the
arrow on each rock points towards the
front of the  replace. (Fig. #7 to 17)

Fig #7

Fig #8

Fig #11

Fig #12

TCWS.38NG04C2 240910-16

Fig #9

Fig #13

5