Town & Country Fireplaces TCWS.38CE2, TCWS.38NG03C3 Instructions Manual
IMPORTANT:
THESE INSTRUCTIONS ARE TO REMAIN
WITH THE HOMEOWNER
These instructions are supplementary to the Installation
and Operating Instructions supplied with the replace
and should be kept together. Refer to the Installation
and Operating Instructions for proper gas supply, safety
requirements and operating instructions.
BLACK DIAMOND
BURNER KIT
INSTRUCTIONS
281112-12 5056.425235 TCWS.38NG03C2
PART#TCWS.38NG03C3
For use with
Model TCWS.38CE2
Series C
2 BURNER ASSEMBLIESR
1 BURNER TRAY
1 5 LB GLASS MEDIA
1 HARDWARE PACK
Contents of Package
TCWS.38NG03C3 281112-12
2
Black Diamond Burner Installation
If converting to propane see
conversion instructions on page #5
before proceeding.
Install panels according to the
TCWS.38CE2 Installation and
Operating manual prior to burner
installation. (Page 26)
1. Install the right burner by tipping into
location trough and slipping the venturi
tube over the ori ce. Repeat with left
burner. (Fig. #1)
NOTE: check air shutter for correct fuel
setting before proceeding further. Both
burner shutters are to be set the same,
fully closed for natural gas. 1/8” (0.125)”
open for LP.
CAUTION: The burners should be tightly
butted up against each other at the center
to ensure correct operation.
Fig #1
Fig #2
2. Tilt burner tray length-wise and insert
into the rebox. (Fig. #2)
3. Attach pilot to burner tray. 2 screws.
(Fig. #3)
4. Secure the burner tray to the manifold
brackets. (6 screws) Fig. #4.
Fig #3
Fig #4
TCWS.38NG03C3 281112-12
3
5. Place glass media into the burner
tray and spread evenly over the
burners and burner tray.(Fig. #5)
Fig #5
7. Place the front porcelain trim so
that it rests on the front shelf of
the rebox and is snug against the
rebox frame.
Ensure that the wide edge of the
trim is facing the center of the
rebox.(Fig. #6))
Fig #6
PORCELAIN TRIM
WIDE EDGE TO CENTER OF
FIREPLACE WITH FRONT
TRIM, TO THE REAR OF THE
FIREBOX FOR REAR TRIM.
Fig #7
TCWS.38NG03C3 281112-12
4
Loading...