Town & Country Fireplaces TC54, TC54 D2 Series Dimension Manual

FOR ARCHITECTS & DESIGNERS

TC54

SERIES D

IMPORTANT
This booklet is intended as a basic specication guide
for architects, designers and builders. Please refer to the
Instruction Manual supplied with the replace for detailed
information regarding installation and operation.

Product installation manuals can also be viewed at:
www.townandcountryreplaces.com

5056.9054-A

Dimensions | Clearances | Venting

TC54.D

280915-12

62 9/16"

35 5/8"

Fireplace Dimensions

63 7/8"

FRAMING

LINTEL

34 1/8"

54 5/16"

Must allow for minimum 1/2 inch
gap for non-combustibel board
and facing

Examples of Common Locations

See “Minimum Combustible Framing Dimensions”
section on page 6 for precise framing dimensions.

48 1/8" 44 1/2"

34 1/8"

TC54D Cad Drawing

Available at
www.townandcountryreplaces.com

For diagonal installation, corner
of fireplace should maintain
standoff distance of 2” to
combustible framing material.

FOR REFERENCE ONLY. CONSULT MANUAL BEFORE INSTALLATION

280915-12

For diagonal installation, corner
of control box is permitted to
make contact with combustible
framing material.

2

5056.9054-A_TC54D

Direct Vent Roof Installation

NOTE: A vertically vented TC54
cannot be power-vented.

Minimum total vent height for
propane: 20 feet.

48'

MAX.

40'

20'

Vertical termination cap

dimensions

16 1/2”

9”

Termination cap shown without
vertical vent pipe. For vent terminal
minimum clearances, see Roof Pitch

Table and Vent Terminal Minimum
Clearances Table - both on page 8.

Minimum total vent height for
natural gas: 10 feet.

Minimum 5’ of vertical vent
required before 1st elbow.

FOR REFERENCE ONLY. CONSULT MANUAL BEFORE INSTALLATION

10'

4' MAX.

'

5

3

280915-125056.9054-A_TC54D

Wall Termination Venting

This unit can be vented horizontally (wall termination) ONLY with an approved High Capacity
Power Vent Kit (TCVT.PVAX2) using TC 8x11 Vent Pipe.

Blower outlets

Power vent
terminal

Finished exterior wall

29 5/8”

16 3/4”

Power vent terminal

19 1/8”

Power vent dimensions

Maximum vent length is 66 ft plus six 90 degree elbow or combination of other elbows equaling 90 degrees.
Minimum vent length is 10 ft plus one 90 degree elbow. The vent can be installed with any combination of
rise and run between the above figures including 3ft below the unit.

The premium Power Vent fan runs quietly outside, at the exterior terminal.

FOR REFERENCE ONLY. CONSULT MANUAL BEFORE INSTALLATION

280915-12

Up to 66 feet of run
plus six 90º elbows

Up to 3 feet below unit

4

Power vent
terminal

TC54D Cad Drawing

Available at
www.townandcountryreplaces.com

5056.9054-A_TC54D