Town & Country Fireplaces TC42.NG04D Installation Instructions Manual
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
These instructions are supplementary to the Installation and
Operating Instructions supplied with the replace and should be
kept together. Refer to the Installation and Operating Instructions for
proper gas supply, safety requirements and operating instructions
TC42
TRANQUILITY
BURNER KIT
INSTALLATION
INSTRUCTIONS
Visit www. townandcountryfi replaces.net for the most recent version of this manual
090117-16 TC42_NG04D 5056.426D4
PART# TC42.
NG04D
For TC42 Series D
Fireplaces
1 Burner assembly
1 Panel, base
1 Pebble assembly
1 Cover, right side
1 Cover, left side
3.4 lbs sand
1 Bag tapered plugs
Contents of Package
Figure 1: Tranquility burner kit package contents.
Tranquility Burner Installation
If converting to propane see conversion instructions on page 10 before proceeding.
NOTE: Plug the 4 vacant holes in the bottom of the firebox with 1/2” screws, as they are not required to
attach this style of burner.
1. Reshape the pre-existing gas ex lines into the approximate shape needed to t the new burner (Figure 2).
2. Place left and right covers under the burner tray (Figure 2 and Figure 3).
NOTE: Shutter must be fully closed for Natural gas, fully open for Propane.
Figure 2: Pre-existing gas ex lines. Figure 3: Left side cover.
5056.426D4
Figure 4: Right side cover.
2
TC42_NG04D_090117-16
Figure 5: Lower rear panel.
3. Position lower rear porcelain panel centered at the rear of the rebox. Place burner assembly into the
rebox against the rear panel (Figure 5).
Figure 6: Panel clips.
4. Place panel clips under both rear corners of the base plate as shown in Figure 6 (approx. 3” from rear
panel).
TC42_NG04D_090117-16
3
5056.426D4
Figure 7: Gas and pilot supply tubes.
5. Attach the manifold supply tube and the pilot supply tube to the bulk head ttings and tighten (Figure 7).
Ensure that there are no leaks.
Ignition and sensor wires
Bulkhead plate
Figure 8: Ignition and sensor wires routing.
6. Secure the electrical bulkhead plate and gasket to the rebox with 2 screws (Figure 8).
5056.426D4
4
TC42_NG04D_090117-16
Flame sensor
wire (white)
Interface module
Figure 9: Interface module.
7. Attach the ignition and sensor wires to the module (Figure 9).
Ignition wire (red)
Figure 10: Right side panel installation.
8. Remove panel retainer from upper heat shield. Install right porcelain panel tilting in from front corner
(Figure 10).
TC42_NG04D_090117-16
5
5056.426D4
Loading...