Town & Country Fireplaces TC42.NG02DN Installation Instructions Manual

INSTALLER: Leave this manual with the appliance.

CONSUMER: Retain this manual for future reference.

These instructions are supplementary to the Installation and
Operating Instructions supplied with the  replace and should be
kept together. Refer to the Installation and Operating Instructions for
proper gas supply, safety requirements and operating instructions

TC42
COUNTRY HOME
BURNER KIT
INSTALLATION
INSTRUCTIONS

(NATURAL GAS ONLY)

Visit www. townandcountryfi replaces.net for the most recent version of this manual

100117-12 TC42_NG02DN 5056.426C8

PART# TC42.NG02DN
For TC42 Series D
Fireplaces

• Ember material

• 7 Piece log set

• Log grate

• Burner assembly

(including pilot and manifold)

• Hardware package
(not shown)

• Air deflector

Contents of Package

Figure 1: TC42 NG02 kit contents

Burner Installation

1. Place the keyhole slots in the burner (Figure 2) over the two screws located in the rebox base (Figure 3).

2. Slide the burner back to engage the screws in the small part of the keyhole slot and tighten screws.

3. Remove the valve control box access cover from side of rebox (Figure 4).

Bolts

Figure 3: Bolts for burner.

Figure 2: Attaching burner to oor of replace.

Figure 4: Control center access cover.

5056.426C8

2

TC42_NG02DN_100117-12

4. Attach the manifold and pilot
supply tubes to the bulk head
tting and tighten (Figure 5).

Ensure that all connections
are gas tight.

Figure 5: Gas and pilot supply tubes.

5. Feed the ignition and sensor
wires through the bulkhead
plate (Figure 6) to the inter­face.

Ignition and sensor wires

Bulkhead plate

Figure 6: Ignition and sensor wires routing.

TC42_NG02DN_100117-12

3

5056.426C8

6. Attach the ignition and sensor
wires to the module (Figure 7)

7. Reinstall the access panel to
the valve control box.

A panel set must now be
installed. See Installation and
Operating Instructions manual
for details.

Figure 7: Interface module.

Interface module

Flame sensor
wire (white)

Ignition wire (red)

8. Position the slots of the grate
securing brackets over the
holes in the oor shield and
secure with the two screws
(Figure 8).

Figure 8: Securing the grate.

5056.426C8

4

TC42_NG02DN_100117-12