Town & Country Fireplaces TC36.NGST04C Instructions Manual

IMPORTANT:
THESE INSTRUCTIONS ARE TO REMAIN
WITH THE HOMEOWNER

These instructions are supplementary to the Installation
and Operating Instructions supplied with the replace
and should be kept together. Refer to the Installation
and Operating Instructions for proper gas supply, safety
requirements and operating instructions.

TC36 See-Thru
TRANQUILITY
BURNER KIT
INSTRUCTIONS

101812-16 TC36.NGST04C 5056.42801C4

PART#TC36.NGST04C

FOR TC36 SEE-THRU
SERIES C

Package Contents

5 lbs. Sand 5096.9935
1 Bag tapered plugs TC36.503152
1 Burner assembly TC36.9410
2 Line covers TC36.9699PBKA
1 Pebble assembly TC42.9499
1 Instruction pack 5056.42801.C4

Tranquility Burner Installation

In these instructions the right and left sides of the
replace are referenced during the installation
process. The right side has the control access
cover in it.

1) Place base panels onto unit oor.

2) Attach a line cover to the left side of rebox
using screw from top center of air channel.
(Fig #1)

3) Remove panel retainer clips from the top heat
shield. Install left porcelain panel. (Fig #2)

Fig #1

Fig #2

TC36.NGST04C 101812-16

2

Tranquility Burner Installation

If converting to propane see
conversion instructions on page #6
before proceeding.

Set shutter according to fuel used. Fully open
for propane, closed for natural gas.

4) Place burner assembly into center of porcelain
base panels. (Fig #3)

5) Attach fuel ex lines to bulkhead ttings.

(Fig #4)

CAUTION: Ensure that all

connections are gas tight.

Fig #3

Fig #4

TC36.NGST04C 101812-16

3

6) Secure the electrical bulkhead plate and
gasket to the rebox. (2 screws) Attach the
ignition and sensor wires to the module. Red
end to the connector marked by the red dot,
white end to the connector marked by the
white dot(Fig. #5 & 6)

2 SCREWS

Fig #5

BULKHEAD PLATE

Fig #6

WHITE END TO
WHITE DOT

MODULE

RED END TO
RED DOT

TC36.NGST04C 101812-16

4

7) Place second line cover over lines and
attach to right side of rebox using top
bulkhead screw. (Fig #7)

8) Install right porcelain panel and re-install panel

retainer clips. (Fig #8)

Fig #7

Fig #8

TC36.NGST04C 101812-16

5