Town & Country Fireplaces TC36.NG01 Installation Manual

CHALET BURNER KIT

TC36.NG01

PACKAGE CONTENTS:

• BURNER ASSEMBLY PART# TC36.9787

• LOG GRATE PART# TC36.9181

• 6 PCS LOG SET PART# 5098.7461

• EMBER MATERIAL PART# 5096.981.B

• HARDWARE PACKAGE PART# TC36.NGHDWR

These instructions are supplementary to the Installation and Operating
Instructions supplied with the  replace and should be kept together. Refer
to the Installation and Operating Instructions for proper gas supply, safety
requirements and operating instructions.

IMPORTANT: THESE INSTRUCTIONS

070205-8 TC36.NG01 5056.427.1

ARE TO REMAIN WITH THE

APPLIANCE INSTRUCTIONS

CONTROL BOX RELOCATION

The gas control system is housed in a control box remote
of the  replace. Flexible conduits attach the control box to
the  replace and house all the the plumbing and wiring to
the burner.

The control box is shipped inside the  rebox and needs to be
installed. Although the control box may be install on the right
or left side, the  replace is assembled at the factory to accept
the control box from the right hand side. (Fig. # 1)

If installing on the left hand side, the casing and  rebox inlet
covers must  rst be removed and reinstalled on the opposite
side of the unit. The manifold will also need to be repositioned
once the burner is installed. This is done by removing two
retaining screws, turning the manifold over and re-attaching.
See Fig. #3.

DEFAULT INSTALLATION

1) Insert the inlet box into the opening at the base of the right
hand side of the unit as shown in  g # 1 taking care not
to damage pilot, plumbing or wires.

2) Install 4 screws from the inside of the  rebox to secure
the inlet box to the  rebox.

3) Install Panel Set. (Refer to “Firebox Panels Installation”
in the Installation and Operating Instruction manual)

Fig. # 2

INSTALL SCREWS TO SECURE INLET BOX

A panel set must be installed prior to the installation of
the burner/grate assembly. See Installation and Operating
Instructions manual for details.

Fig. # 1

INLET BOX

INSERT CONTROL ASSEMBLY

Fig. # 3

REPOSITION MANIFOLD

2 TC36.NG01 080205-8

BURNER/GRATE INSTALLATION

1) Attach the burner assembly to the  oor shield in the bottom
of the  rebox with two screws ensuring that the front edge
of the burner is  ush with the front of the shield.

See  g. # 4.

2) Attach pilot bracket to burner assembly. (Fig. # 5)

3) Connect  ex gas line to the manifold assembly and ensure
the connection is gas tight.

4) Position the grate in the slots of the burner tray and attach
to the  oor shield with two screws through holes located
behind the front legs of the grate. (Fig. # 6)

Fig. # 5

ATTACH PILOT BRACKET TO

BURNER ASSEMBLY

Fig. # 4

BURNER TRAY INSTALLATION

Fig. # 6

GRATE INSTALLATION

080205-8 TC36.NG01 3