Town & Country Fireplaces TC30.NG04C Instructions Manual

IMPORTANT:
THESE INSTRUCTIONS ARE TO REMAIN
WITH THE HOMEOWNER

These instructions are supplementary to the Installation
and Operating Instructions supplied with the  replace
and should be kept together. Refer to the Installation
and Operating Instructions for proper gas supply, safety
requirements and operating instructions.

TC30
TRANQUILITY
BURNER KIT
INSTRUCTIONS

180411-20 TC30.NG04C 5056.42904

PART#

TC30.NG04C
For TC30 Series C

1 BURNER ASSEMBLY

1 PANEL, BASE

1 PEBBLE ASSEMBLY

2.2 LBS. SAND

1 COVER RHS

1 COVER LHS

1 BAG TAPERED PLUGS (NOT SHOWN)

Contents of Package

Tranquility Burner Installation

If converting to propane see conversion instructions on page #6
before proceeding.

NOTE: Plug the 4 vacant holes in the bottom of the  rebox with 1/2” screws,
as they are not required to attach this style of burner.

1. Bend  ex lines into the approximate shape. (Fig #1)

2. Place covers under the burner tray. (Fig #2 & 3)

NOTE: Shutter must be fully closed for Natural gas, half open for Propane.

Fig #1

Fig #2

Fig #3

TC30.NG04C 180411-20

2

3. Position lower rear porcelain panel
centered at the rear of the  rebox. Place
burner assembly into the  rebox against
the rear panel.

(Fig #4)

4. Attach the manifold supply tube and

the pilot supply tube to the bulk head
 ttings and tighten. (Fig. #5) Ensure
that there are no leaks.

Fig #4

Fig #5

TC30.NG04C 180411-20

3

5. Secure the electrical bulkhead plate and

gasket to the  rebox. (2 screws) Attach the
ignition and sensor wires to the module.
Red end to the connector marked by
the red dot, white end to the connector
marked by the white dot(Fig. #6 & 7)

2 SCREWS

Fig #6

BULKHEAD PLATE

Fig #7

WHITE END TO
WHITE DOT

MODULE

RED END TO
RED DOT

TC30.NG04C 180411-20

4

6. Remove panel retainer clips from upper
heat shield. Install right porcelain panel
tilting in from front corner. Secure the
right panel with one of the previously
removed panel retainer clips. (Fig #8)

Fig #8

7. Bend up retaining clip on the left panel.
Position upper rear panel on the top of
the lower rear panel and behind the right
panel. While supporting the upper rear
panel install and secure the left panel in
the same manner as the right panel.

(Fig #9)

Fig #9

TC30.NG04C 180411-20

5

8. Bend the retaining clip down over the
upper back panel.

(Fig #10)

NOTE: The clips can be adjusted side

to side to minimize any gaps between
the panels.

9. Slide covers out and attach to base with
one screw each.

(Fig #11)

Fig #10

Fig #11

TC30.NG04C 180411-20

6