Town & Country Fireplaces TC30.NG03D Instructions Manual

INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.

These instructions are supplementary to the Installation
and Operating Instructions supplied with the replace
and should be kept together. Refer to the Installation
and Operating Instructions for proper gas supply, safety
requirements and operating instructions.

TC30
BLACK DIAMOND
BURNER KIT
INSTRUCTIONS

270315-16 TC30_NG03D 5056.42903D

PART#

TC30.NG03D
For TC30 Series D
Fireplaces

Contents of Package

A

B

C

F

D

E

NOTE:
MUST BE USED WITH PORCELAIN PANEL SET PART# TC30.PNLPBKB

A MANIFOLD ASSEMBLY

(including supply tube)

B BURNER TUBE

C BURNER SHIELD

D MEDIA SPACER, Center

E MEDIA SPACER, Front

F MEDIA SPACER, Rear

G HARDWARE PACKAGE

H 5 lbs. GLASS MEDIA

I BURNER TRAY

J PILOT SHIELD

(including pilot and pilot supply tube)

I

G

J

H

5056.42903D

TC30_NGO3D_270315-16

2

Black Diamond Burner Installation

A porcelain panel set must be used
in conjunction with the installation of
the burner assembly. See Installation
and Operating Instructions manual for
details.

NOTE: Plug the 4 vacant holes in the
bottom of the rebox with 1/2” screws,
as they are not required to attach this
style of burner.

NOTE: If unit is to be converted to Propane,
see Propane conversion instructions on
page 7 before proceeding.

1. Remove three screws from the rear of
the rebox. Attach the manifold bracket
to the rear of the rebox with the three
screws previously removed. (Fig. #1)

Fig #1

2. Attach the manifold supply tube and the
pilot supply tube to the bulk head ttings
and tighten. (Fig. #2) Ensure that there
are no leaks.

Fig #2

TC30_NGO3D_270315-16

3

5056.42903D

4. Secure the electrical bulkhead plate
(Fig.#3) and gasket to the rebox. (2
screws) Attach the ignition and sensor
wires to the module. (Fig.#4).

2 SCREWS

Fig #3

BULKHEAD PLATE

Fig #4

IGNITION
WIRE
(RED)

FLAME
SENSOR
WIRE
(WHITE)

INTERFACE
MODULE

5056.42903D

TC30_NGO3D_270315-16

4

4. Install burner shield by tipping the shield
into the rebox. Route pilot up through
the opening in the burner shield.

(Fig. #5)

Fig #5

PILOT

5. Attach the burner tray to the burner shield
using two screws at the back of the tray.
(Fig. #6)

Fig #6

TC30_NGO3D_270315-16

5

5056.42903D