Town & Country Fireplaces TC30.NG02CN Instructions Manual

INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.

These instructions are supplementary to the Installation and
Operating Instructions supplied with the  replace and should be
kept together. Refer to the Installation and Operating Instructions
for proper gas supply, safety requirements and operating
instructions

TC30
COUNTRY HOME
BURNER KIT
INSTRUCTIONS

(NATURAL GAS ONLY)

PART#

130411-12 TC30.NG02CN 5056.42902

TC30.NG02CN
For TC30 Series C

BURNER ASSEMBLY

7 PCS LOG SET

HARDWARE PACKAGE

EMBER MATERIAL

LOG GRATE

Contents of Package

Burner/Grate Installation

1. Place the keyhole slots in the burner
over the two screws located in the  rebox
base. (Fig. #1 & 1a)

2. Slide the burner back to engage the
screws in the small part of the keyhole
slot and tighten screws. (Fig. #1b)

3. Remove access cover from side of
 rebox(Fig. #1c)

Fig. # 1

SCREWS

Fig. # 1c

Fig. # 1a

Fig. # 1b

TC30.NG02CN 130411-12

2

Burner/ Grate Installation

4. Secure the electrical bulkhead plate and
gasket to the  rebox. (2 screws) Attach the
ignition and sensor wires to the module.
Red end to the connector marked by the
red dot, white end to the connector marked
by the white dot

Fig.#2 & Fig.#3

Fig. # 2

2 SCREWS

BULKHEAD PLATE

Fig. # 3

WHITE END TO
WHITE DOT

MODULE

RED END TO
RED DOT

TC30.NG02CN 130411-12

3

5. Attach the pilot and gas supply tubes to

the bulk head  tting and tighten.
(Fig. # 3b) Ensure the connections are
gas tight. Conceal the spark and
sensor wires below the supply tubes.

A panel set must now be installed. See

Installation and Operating Instructions
manual for details.

Fig. # 3b

PILOT SUPPLY
TUBE

MAIN GAS SUPPLY
TUBE

6. Position the slots of the grate securing

brackets over the holes in the  oor shield
and secure with the two screws

(Fig. # 4).

Fig. # 4

TC30.NG02CN 130411-12

4

7. Attach rear de ector to rear of grate
using the two screws provided
(Fig. # 5).

Fig. # 5

AIR DEFLECTOR
SECURING
SCREWS

Ember Material Placement

A large bag of ember material is shipped with
the  replace and needs to be installed to ensure
optimum performance and  ame appearance.

Pull apart the material into ember size pieces
(approximately 1” squares) and gently place them
into the burner pan. Do not compress, leave it loose
for best performance.

Fill the burner pan level with the top of the pan at
rear, and gradually slope forward to the  rebox  oor
at the front, covering both burner tubes.

Place remaining ember material outside of the
burner pan as desired to cover-up gas lines and
brackets.

Note: Ember material placement and amount will
affect  ame appearance. More ember material
results in lower  ame height. Add or remove as
needed until desired  ame affect.

Fig. # 5b

TC30.NG02CN 130411-12

GLOWING EMBERS

5