Page 1
REQUIRES
INCLUDES
2-Cell, 7.4V LiPo Battery
(DTXC18861 recommended)
Balancing Charger
(DTXP4620 recommended)
Four AA Alkaline Batteries
(DTXP4704 recommended)
Cutback Short Course Truck
2-Channel 2.4GHz Radio System
Optional 54 Tooth Spur Gear
Optional Rear Toe-In Blocks
(Two of each: 2.0°, 3.0°, 3.5°)
For more information on the Cutback SC, please go to towerhobbies.com/products/towc0500.html
®
We have engineered the
Cutback to take the rough and
tumble abuse that makes R/C fun.
We are so confi dent of the quality and
durability of the Bash-Proof plastic parts
that we will replace any plastic part you
break during the fi rst 12 months you own
your Cutback. Just send in the part to us
and we will send you a FREE replacement!
To receive your free replacement part,
please send the following to Hobby
Services (address on back cover):
1. The broken part
2.
The part number & description of the
broken part.
3. Copy of your invoice.
4. Your Tower Hobbies customer number.
Page 2
2S 3S
4S
5S
6S
CHARGER
LIPO BATTERY
+
–
Throttle
Reversing
Switch
Steering
Reversing
Switch
Steering
Trim
Throttle
Trim
Steering
Dual Rate
Forward
Reverse
Forward
R
1. CHARGE THE LIPO BATTERY
7. RE-BINDING THE TRANSMITTER TO THE RECEIVER
3. INSTALL TRANSMITTER BATTERIES2. INSTALL RECEIVER ANTENNA TUBE
6. FAILSAFE5. INSTALL/CONNECT LIPO BATTERY TO ESC4. CHECK TRANSMITTER
IMPORTANT! Never leave a charging battery unattended!
If the battery swells or becomes hot, disconnect immediately!
Note: ALWAYS turn on your transmitter
fi rst and then your ESC. When fi nished,
ALWAYS turn off your ESC fi rst and then
your transmitter.
Charge your battery per the
manufacturer’s specifi cations.
Your radio system is preset at the factory.
If you need to re-bind your system, follow
these steps.
A. Insert the bind plug into
channel 3 on the receiver.
B. Turn on the ESC. The
receiver LED should
start blinking.
Receiver LEDBind Plug
Transmitter
Bind Button
On/Off
Switch
C. Press and hold down the transmitter’s bind button and turn
the transmitter on. The receiver LED will stop blinking.
D. Turn off the ESC and transmitter and
remove the bind plug from the receiver.
Install (4) AA batteries.
Important: When not
in use, disconnect your
battery from the ESC.
Route the antenna.
TO SET:
1. Power up the transmitter and receiver.
2. Hold the vehicle so the wheels are off the ground and
clear of all objects.
3. With the transmitter throttle in neutral, press the
failsafe set button on the receiver. The receiver LED
will fl ash to indicate a new failsafe point has been set.
The receiver has a built-in failsafe. If it loses
contact with the transmitter, it will automatically
return the throttle to a preset point.
Failsafe
Set Button
Page 3
FCC STATEMENT
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions.
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
FCC RF Radiated Exposure Statement: The equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters
between the radiator and your body.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY
UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.
FCC ID: XY4RZT24G
SPECIFICATIONS & DESCRIPTION CHANGES
All information found in this manual is subject to change without notice. Visit towerhobbies.com for the latest updates and
information on your model. Tower Hobbies maintains no responsibility for inadvertent errors in this manual.
SAFETY PRECAUTIONS
To prevent injury and damage to property, follow these safety precautions when operating any radio control vehicle.
•
Keep all spectators a safe distance away from the vehicle.
•
ALWAYS turn the transmitter on before the receiver.
•
ALWAYS disconnect the battery from the ESC when fi nished running.
•
Use a mat or towel when working on your model to protect your work surface.
•
Do NOT run your radio control vehicle in cold weather as plastic parts may become brittle.
•
ALWAYS have a “Class D” fi re extinguisher available when handling LiPo batteries.
LIMITED WARRANTY
Tower Hobbies guarantees this kit to be free from defects in materials or workmanship for 180 days after the date of purchase. Tower
Hobbies will repair or replace at no charge any incorrectly made part.
Your receipt or invoice at time of purchase is your proof of purchase and is required for Tower Hobbies to honor any warranty. Tower
Hobbies reserves the right to change or modify this warranty without notice.
For warranty repairs, contact or send to:
Hobby Services
3002 N. Apollo Drive Suite 1
Champaign, IL 61822
ATTN: Service Department
Phone: (217) 398-0007
9:00 am – 5:00 pm Central Time M-F
E-mail: hobbyservices@hobbico.com
www.hobbyservices.com
If the buyer is not prepared to accept the liability associated with the use of this product, the buyer is advised to return the kit immediately
in new and unused condition to the place of purchase.
REPAIR SERVICE
Hobby Services offers repair services after the 180 day limited warranty for a minimal charge.
Follow these instructions for your repair request:
1.
Most circumstances require the return of the ENTIRE vehicle.
2. Remove ALL the batteries.
3. Include written instructions listing ALL items being returned with a THOROUGH description of the problem, service
needed and your DAYTIME phone number. IF you expect the repair to be covered under the 180 day limited warranty,
include copy of receipt or invoice with date of purchase.
4. Send to Hobby Services at the address above. When shipping your item(s) to us, we recommend that you insure them
and use a company that offers tracking service (such as UPS or Federal Express).
We will carefully inspect your item and notify you of our fi ndings. You will be advised of your options for return, repair, or
replacement. Please note that items sent back unrepaired will carry a return shipping and service charge.
Hobby Services accepts Visa® and MasterCard®, or you can send a check. We can return the item C.O.D., but additional
charges will apply.
Made in Taiwan
TOWC0500mnl
towerhobbies.com
© 2014Tower Hobbies. A subsidiary of Hobbico, Inc.
Loading...