![](/html/8e/8e27/8e27ed0d8af3ccfe1444c97c2095c5c2b61f8b8b96c9bf63d3764470fa15745b/bg1.png)
ELECTRIC FLAT PANEL FIREPLACE
Model# :80017
OWNER’S MANUAL
50/60”- Built-in & Wall Mounted Electric Fireplace
AC 110-120V 60Hz
Read and understand this entire owner’s manual, including all safety
WARNING
CAUTION
information, before plugging in or using this product. Failure to do so could
result in fire, electric shock, or serious personal injury.
Keep this owner’s manual for future reference. If you sell or give this
product away, make sure this manual accompanies this product.
![](/html/8e/8e27/8e27ed0d8af3ccfe1444c97c2095c5c2b61f8b8b96c9bf63d3764470fa15745b/bg2.png)
IMPORTANT SAFETY INFORMATION!
WARNING
Read all instructions before using this fireplace!
DO NOT operate any fireplace with a damaged cord or plug or after the fireplace
malfunctions, has been dropped or damaged in any manner. Discard fireplace, or return to
authorized service facility for examination and/or repair.
DO NOT run power cord under carpeting. DO NOT cover power cord with throw rugs, runners,
or similar coverings. DO NOT route power cord under furniture or appliances. Arrange power
cord away from traffic area, and where it will not be tripped over.
Connect to properly grounded outlets ONLY.
DO NOT insert or allow foreign objects to enter any ventilation or exhaust opening, as
this may cause electric shock or fire, or damage the fireplace.
To prevent a possible fire, DO NOT block air intakes or exhaust in any manner. Doing so could
cause a fire. DO NOT use on soft surfaces, like a bed, where openings may become blocked.
A fireplace has hot and arcing or sparking parts inside. DO NOT use it in areas where
gasoline, paint, or flammable liquids are used or stored.
Use this fireplace only as described in this manual. Any other use not recommended by
the manufacturer may cause fire, electric shock, or injury to persons.
AVOID FIRE! Regularly inspect all air vents to make sure they are free from dust, lint, or other
blockage. Unplug the unit and clean with a vacuum ONLY. DO NOT rinse or get wet.
NEVER hang this unit on a wall directly below an electrical outlet.
NEVER permanently install in a recessed area of the wall. This may result in blocked air
flow, overheating, or fire.
ALWAYS mount to wall bracket before use. DO NOT set on the floor, or other surface, to use.
NEVER use a wall mount bracket from another manufacturer.
For residential use only! NOT for commercial use! Any commercial or public use of this
fireplace voids all warranties, and could cause injury.
This product is not intended to be a primary heat source. It is for supplemental heat only.
INDOOR and OUTDOOR use!
Risk of electric shock! DO NOT OPEN! No user-serviceable parts inside!
NEVER modify this fireplace. Doing so could result in personal injury or property damage.
Modification of this fireplace completely voids all warranties.
ALWAYS turn this fireplace off before unplugging it from the outlet.
ALWAYS disconnect this unit from the power supply before performing any assembly or
cleaning, or before relocating the electric fireplace.
NEVER leave this fireplace unattended. ALWAYS unplug this fireplace when not in use.
2
![](/html/8e/8e27/8e27ed0d8af3ccfe1444c97c2095c5c2b61f8b8b96c9bf63d3764470fa15745b/bg3.png)
ONLY use this fireplace on a 120V AC 10-Amp grounded circuit. NEVER overload the
circuit. If this fireplace trips the circuit breaker, unplug all other appliances on the same circuit
before the next use. Avoid plugging other appliances into the same circuit as this fireplace.
NEVER plug this fireplace into an outlet that is old, cracked, or has any loose wires or
connections. Plugging this fireplace into a faulty outlet could result in electric arcing within
the outlet that could cause the outlet to overheat or catch fire.
ALWAYS check your fireplace cord and plug connections with each use!
i) MAKE SURE the plug fits tight in the outlet! Faulty wall outlet connections or loose plugs
can cause the outlet to overheat.
ii) fireplaces draw more current than small appliances. Overheating may occur even if it
has not occurred with the use of other appliances.
iii) During use check frequently to see if the plug outlet or faceplate is HOT!
iv) If the outlet or face plate is HOT, discontinue use immediately and have a qualified
electrician inspect and/or replace the faulty outlets.
The power cord supplied with the fireplace has three
prongs: two flat blades (live and neutral) and one
round pin (ground). If a 3-slot receptacle is not
available, an adapter MUST be used. The adapter
MUST be properly grounded to the outlet box (see
figure at right). [NOTE: Adapter NOT INCLUDED.]
With Leakage protection plug.
SAVE THESE INSTRUCTIONS!
Preparation
This product includes a GLASS panel! Always use extreme caution when handling
glass. Failure to do so could result in personal injury or property damage.
Remove all parts and hardware from the carton and place them on a clean, soft, dry surface. Parts
and assembly steps are grouped for free-standing or wall-hanging use. Check the parts list to make
sure nothing is missing. Dispose of packaging materials properly. Please recycle whenever possible.
You will need the following tools (not included): Phillips screwdriver; stud finder; level; tape
measure; electric drill; 1/4” wood drill bit, hammer.
3
![](/html/8e/8e27/8e27ed0d8af3ccfe1444c97c2095c5c2b61f8b8b96c9bf63d3764470fa15745b/bg4.png)
Parts and Hardware
B – Wood Screws ( 4) C – Drywall anchors (4 )
A – Fireplace ( 1 )
RC – Remote Control (1)
Installation and Assembly
Rear View of Fireplace
Minimum 39.4”
19.7”
(50 cm)
(100 cm)
Minimum
19.7” (50 cm)
19.7”
(50 cm)
Step 1. Find a safe location.
Minimum clearance on each side:
19.7” (50 cm).
Minimum clearance below:
19.7” (50 cm).
Minimum clearance above:
39.4” (100 cm).
Minimum clearance from the front
and sides: 19.7” (50 cm).
Choose a location near an outlet so
an extension cord is not required.
DO NOT position the unit directly
below a power outlet.
See Safety Information on pages
2 and 3 for warnings about safe
placement, safe installation, and
proper use of this product.
ALWAYS unplug this fireplace fireplace before assembly or cleaning, or before
relocating. Failure to do so could result in electric shock, fire, or personal injury.
4