Touchstone 80004 User Manual

User's Manual

80004: Sideline Electric Fireplace

MODEL: 80004

Read this owner's manual very carefully before using fireplace.

Please retain for future reference.

IMPORTANT: It is important to read these instructions carefully before using the appliance for
the first time. Keep the instructions so that you can refer to them later if necessary.

IMPORTANT INSTRUCTIONS

When using electrical appliances basic precautions should always be followed to reduce the risk of fire,
electric shock and injury to persons, including the following:

1) Read all instructions before using this heater.

2) This heater is hot when in use. To avoid burning, do not touch hot surface. If provided, use handles
when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers,
clothes, and curtains at least 3 ft. from the front of the heater and keep them away from the sides and
rear. In order to avoid overheating, do not cover the heater.

3) Extreme caution is necessary when any heater is used near children and whenever the heater is left
operating and unattended.

4) Unplug heather when not in use for extended period of time.

5) Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been
dropped or damaged in any manner, return heater to authorized service facility for examination,
electrical or mechanical adjustment, or repair.

6) Do not use outdoors.

7) This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never
locate heater where it may fall into a bathtub or other water container.

8) Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings.
Arrange cord away from traffic area and where it will not be tipped over.

9) To disconnect heater, turn controls to off, then remove plug from outlet.

10) Do not inset or allow foreign objects to enter any ventilation or exhaust opening as this may cause
an electric shock or fire, or damage the heater.

11) To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft
surfaces, like a bed, where openings many become blocked.

12) Do not use it in areas where gasoline, or flammable liquids are used or stored.

13) Use this heater only as describes in this manual. Any other use not recommended by the
manufacturer may cause fire, electric shock, or injury to persons.

14) DANGER: High temperatures may be generated under certain abnormal conditions. Do not partially
or fully cover or obstruct the front of this heater.

15) Replacement of the lamps should be done only while the heater is powered off and unplugged from
the electrical outlet.
16）Children should be supervised to ensure that they do not play with the appliance.

17) CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this
appliance must not be supplied through an external switching device, such as a timer, or connected to a
circuit that is regularly switched on and off by the utility.

1

UNPACKING AND TESTING APPLIANCE

Carefully remove the appliance from the box. Prior to installing the appliance, test to make sure the
appliance operates properly by plugging the power supply cord into a conveniently located 110-120 Volt
grounded outlet.

GROUNDING THE APPLIANCE

This appliance is for use on 120 Volts. The cord has a plug
as shown in (A). An adapter as shown in (C) is available
for connecting three-blade grounding type plugs to two-slot
receptacles. The green grounding lug extending from the
adapter must be connected to a permanent ground such as
a properly grounded outlet box. The adapter should not be
used if a three-slot grounded receptacle is available.

To disconnect appliance, turn controls to off, then remove
plug from outlet.

WARNING:

Keep the front of the appliance through which the heat is
radiated at least 3 feet away from furniture, curtains and

other flammable objects at all time.
Never use an extension lead. The mains cable must remain
at the back of the appliance and must not be in contact with
any hot elements.

2