Page 1
0GU3030
2007.5
®
Wall Spout
TS170E
RENESSE
™
Installation and Owner’s Manual
English
Español
Français
Contents
Important Safeguards---------------1
Specifications -------------------------2
Before Installation--------------------2
Set-Up Drawing -----------------------3
Components ---------------------------3
Installation Procedure -------------4
Shower Setup -------------------------5
Maintenance --------------------------5
Troubleshooting ---------------------6
Replacement Parts-------------------6
Warranty---------------------------------7
Thank you for your recent purchase
•
of the TOTO® product. Please read the
enclosed information to ensure the
safe use of your product.
.
Page 2
Important Safeguards
(For your safety please follow the instructions below)
Read the “ Important Safeguards” section throughly before installing the product.
●Following symbols indicate safe and proper use of the product. Failure to observe them may
result in injury or property damage. The symbols and their meanings are as follows.
●The following table demonstrates the use of safety symbols in this manual.
ENGLISH
Do Not
Caution
Do not connect the pipe adapter (please refer to Page #7) with
spout before attaching it to the water supply pipes.
Failure to observe this
symbol may result in
injury or property damage
Absolutely Do NOT.
Do not disassemble
Mandatory!
Caution
Failure to observe this caution may result in scratches on the spout
or looseness of setscrew.
Do not cause scratches to the O-ring.
Damaged O-ring may cause water leakage.
Do not disassemble or modify the product in anyway not
described in this manual.
Do not
disassemble
Careless disassembly or modification may result in the product failure.
Mount the wall spout firmly so that it may not be loose or
detached while using.
Loose setscrews will make mounting unstable, resulting in injuries.
Mandatory
Handle the threaded portion of showerhead with care.
You may hurt your fingers.
Apply pipe selaing tape to threads.
Failure to observe this caution may result in water leakage.
1
Page 3
Specification
Water Supply
Pressure
Supplied Water Temperature
Water Quality
Ambient Temperature
Water Supply Connection
Humidity
Flow Rate
Depending on the model, some specifications may differ.
Minimum pressure
Maximum pressure
Before installation
20 psi (0.14MPa) (flowing pressure)
125 psi (0.86MPa) (static) Check local building code
Less than 185°F (85°C)
Water that meets National/Primary drinking water regulation
34 -104°F (2 - 40°C)
1/2” NPT
Maximum 90% RH
Max. 2.5 gallons per minutes (9.5L/min)
▪ Observe all local plumbing codes.
▪ Make sure water supply is shut off.
▪ Read these instructions carefully to ensure proper installation.
▪ Check to make sure you have the following parts indicated below.
● If the water supply pressure is higher than 125psi (0.86MPa), you should buy a
reducing valve to reduce the pressure to the range of 0.2-0.3MPa.
To use the faucet comfortably, the recommended pressure is about 30-45 psi
(0.2-0.3MPa).
●To prevent being scalded due to malfunction, the cold water supply pressure must
be higher than the hot water pressure, or you can make them equal. In addition,
if you increase the pressure of the hot water, it still must be lower than that of cold
water supply side.
●To prevent being scalded due to wrong operation, it is recommended the hot water
supply temperature is 140°F (60°C).
●For ease of water flow adjustment and inspection with tools, you should prepare an
extra stop valve.
2
Page 4
Set-up Drawing
Finished Wall
3-1/16” )78 mm)
ENGLISH
Wall Spout
HOT
6-5/16” (160 mm)
COLD
7-1/2” (190 mm)
1/2”
NPT
CAUTION: Hole on the finished wall for Wall Spout water supply pipe
SHOULD NOT be bigger than 1” (25mm). Refer to Installation Procedure.
Components
O-ring
Set screw
pipe adapter
with o-ring
Owner’s and Installation
manual
11/16”
(18mm)
Spout
Spout key
Tools you will need
Pipe Tape
Adjustable Wrench
Allen Wrech
3
Page 5
Installation Procedure
Caution
Wall Spout needs to be connected with a Renesse volume control valve for Shut-off
and a Renesse Thermostatic Mixing Valve for temperature control.
Clean the cold/hot water pipes
1
Before installation
dirt and debris in the cold/ hot water supply pipes must be washed out.
2 Installation of Showerhead
①Put pipe sealing tape around the pipe
Adapter.
②Screw the adapter into water supply pipe
firmly.
pipe sealing tape
Pipe Adapter
with O-ring
Finished Wall
Finished Wall
Finished Wall
O-rings
Caution
MAX. 1” (25 mm)
HOLE
When a hole is made for
wall spout water supply
pipe, MAKE SURE that
the hole is not more than
1” (25mm).
3/16 “ (5mm)
RECOMMENDED:
(standard gap)
Confirm this
gap carefully.
Allowable range:
0 - 3/8”
(0 to 10 mm)
③Screw the spout into the pipe
adapter and
④Face the spout right to the floor and fix it
fimly with setscrew, using an Allen wrench.
PRESS IT ON THE WALL.
NOTE:
●
Be sure to wind the seal tape around
the adapter and tighten it very firmly
●Setscrews are for preventing the product
from falling . Tighten it very cautiously.
●Tighten the setscrew, with the spout
being pressed on the wall.
Finished Wall
Spout
Set screw
Allen Wrench
4
Page 6
Shower Setup Options
Showerhead
TS170A#CP
Bath Spout
TS170E#CP
Hand Shower Trim
TS170F#CP
Single Volume
Control Trim for
Hand Shower
TS170C1#CP
Hand Shower
Adapter
TSKH
TS170T#CP
TSKT
TS170C#CP
Control Valve
TSKA
TS170D#CP
Dual Volume
Control Valve
TSKD
Dual Vol
Control
Trim &
valve
Mixing
Valve Trim
& valve
ENGLISH
Bath Spout
1) Complete Set
Showerhead
Single Vol
Control Trim
& valve
Handshower
Adapter
Handshower
Trim (Trim &
Handshower)
These options are provided for easier reference for customers.
Maintenance
2) w/o Handshower
Showerhead
Dual Vol
Control
Trim &
valve
Mixing
Valve Trim
& Valve
Bath Spout
3) w/o wall spout
Showerhead
Handshower
Dual Vol
Control
Trim &
valve
Mixing
Valve Trim
& valve
Single
Vol Control
Trim & valve
Handshower
Trim (Trim &
Handshower)
Handshower
Adapter
4) Showerhead
4
Single
Vol Control
Trim
& valve
Showerhead
Mixing
Valve Trim
& valve
only
Product
Description
Thermostatic
Mixing Valve Trim
SMA Thermostatic
Mixing Valve
Single Volume
Control Trim for
Head Shower
Single Vol
Dual Volume
Control Trim
#CP = Polished Chrome
Product #
5
For performance and cleanliness, please maintain the product everyday.
Cleaning the spout and the screens with spout key
●Slightly dirty
Use water and a damp cloth to wipe away the
dirt completely.
●Seriously dirty
Use cloth with dilute detergent to wipe away
the dirt, then wash and dry it.
Do not use the following materials
●Acidic cleaning agents, alkaline cleaning agents, or
bleaches that are not TOTO scale cleaner.
●Solvents like thinner and benzene
●Cleaning agents like cleanser or grinding powder
which contains coarse particles
●Nylon scrubbers and brushes
Cleaning the screens with spout key
●Take out the face plate adapter with spout key provided.
●Be carful not to cause scratches while unscrewing the adapter.
●Then, carefully take out the screens and clean them with a
clean brush
●Then, put the screens, o-ring and adapter back on the spout.
Spout
O-ring
Screens
Face plate
adapter
Loosen it
Brush
Spout Key
Screen
Page 7
Troubleshooting
Description
Pipe adapter
Pipe adapter o-ring
Screens
Face plate adapter
Problem
Temperature
can not be
adjusted
easily.
Flow is
too small
Water leak/
Looseness
Check
Is the stop valve on the cold/ Hot sides
fully opened?
Adjust water flow with stop
valve
Solution
Does the water heater give
adequate water?
Are the screens blocked?
Check the wall spout for looseness.
Check settingson water heater
with professional help.
Clean the screens.
Check the adapter for water leak.
Replacement Parts
Refer to
―
―
―
1
4
3
5
6
7
2
No.
1
2
set screw
3
spout
4
o-ring
5
6
7
6
Page 8
WARRANTY
LIFETIME LIMITED WARRANTY
Warranty applies to selected residential faucets only.
1. TOTO
during normal residential use for as long as the original consumer end-user purchaser owns their home. This
limited lifetime warranty is extended only to the original consumer end-user purchaser and only so long as
the Product remains in use by the original consumer end-user purchaser in its original place of installation in
the purchaser’s residence. This warranty applies only to Product purchased and installed in North America.
2. TOTO® obligations under this warranty are limited to repair or replacement, at TOTO®’s
option, of Product or parts found to be defective in normal residential use, provided that such Product was
properly installed and used in accordance with the owner’s manual. TOTO
inspections as may be necessary in order to determine the cause of the defect.
3. This warranty does not apply to the following items:
Damage or loss sustained in a natural calamity such as
etc.
Damage or loss resulting from any accident, unreasonable use, misuse, abuse, negligence, or improper
care, cleaning or maintenance of the Product.
Damage or loss resulting from sediments or foreign matter contained in a water system.
Damage or loss resulting from improper installation or from installation of the Product in a harsh and/or
hazardous environment, or improper removal, repair or modi cation of the Product.
Damage or loss resulting from the use of an abrasive cleanser.
4. If the Product is used commercially, TOTO
materials and workmanship for one (1) year from the date the Product is installed, with all other terms of this
warranty applicable except the duration of the warranty.
5. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS. YOU MAY HAVE OTHER
RIGHTS, WHICH VARY FROM STATE TO STATE OR PROVINCE TO PROVINCE.
6. To obtain warranty repair service under this warranty, you must take the Product or deliver it prepaid to
a TOTO® service facility with proof of purchase (original sales receipt) together with a letter stating the
problem, or contact a TOTO
INC., 1155 Southern road, Morrow, Georgia 30260, (888) 295-8134. If, because of the size of the Product
or nature of the defect, the Product cannot be returned to TOTO®, receipt by TOTO® of written notice of the
defect together with proof of purchase (original sales receipt) shall constitute delivery. In such case, TOTO
may choose to repair the Product at the purchaser’s location or pay to transport the Product to a service
facility.
THIS WRITTEN WARRANTY IS THE ONLY WARRANTY MADE BY TOTO
REPLACEMENT OR OTHER APPROPRIATE ADJUSTMENT AS PROVIDED UNDER THIS
WARRANTY SHALL BE THE EXCLUSIVE REMEDY AVAILABLE TO THE ORIGINAL
PURCHASER. TOTO® SHALL NOT BE RESPONSIBLE FOR LOSS OF THE PRODUCT OR FOR
OTHER INCIDENTAL, SPECIAL OR CONSEQUENTIAL DAMAGES OR EXPENSES INCURRED
BY THE ORIGINAL PURCHASER, OR FOR LABOR OR OTHER COSTS DUE TO INSTALLATION
OR REMOVAL, OR COSTS OF REPAIRS BY OTHERS, OR FOR ANY OTHER EXPENSE NOT
SPECIFICALLY STATED. IN NO EVENT WILL TOTO®’S RESPONSIBILITY EXCEED THE
PURCHASE PRICE OF THE PRODUCT. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE
LAW, ANY IMPLIED WARRANTIES, INCLUDING THAT OF MERCHANTABILITY OR FITNESS
FOR USE OR FOR A PARTICULAR PURPOSE, ARE EXPRESSLY LIMITED TO THE DURATION OF
THIS WARRANTY. SOME STATES AND PROVINCES DO NOT ALLOW LIMITATIONS ON HOW
LONG AN IMPLIED WARRANTY LASTS, OR THE EXCLUSION OR LIMITATION OF INCIDENTAL
OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION AND EXCLUSION MAY NOT
APPLY TO YOU.
®
warrants its faucets (“Product”) to be free from defects in materials and workmanship
®
reserves the right to make such
fire, earthquake,
®
warrants the Product to be free from defects in
®
distributor or products service contractor, or write directly to TOTO
flood, thunder, electrical storm,
®
U.S.A.,
®
. REPAIR,
®
©2007 TOTO USA, Inc. á 1155 Southern Road, Morrow GA 30260
Phone (888)-295-8134 Fax (800)-699-4889 www.totousa.com
TOTO USA, INC. is a wholly owned subsidiary of TOTO Ltd.
Printed in August, 2007
0GU3030
Loading...