Important Safeguards---------------1
Specifications -------------------------2
Before Installation -------------------2
Set-up Drawing------------------------3
Components ---------------------------3
Installation Procedure ---------4~5
Set-up Options -----------------------6
Replacement Parts-------------------6
Warranty---------------------------------7
TS170C1
Thank you for your recent purchase
•
of the TOTO product . Please read
the enclosed information to ensure
the safe use of your product
.
Page 2
Important Safeguards
(For your safety please follow the instructions below)
Read the “Important Safeguards” section thoroughly before installing the product.
●The following symbols indicate safe and proper use of the
product. Failure to observe them may result in injury or
property damage.
The symbols and their meanings are as follows.
Failure to observe this symbol
may result in serious injury.
Failure to observe this symbol may
result in injury or property damage.
Do not use hot water supply that is higher than 185°F
(85°C). Do not use steam as hot water supply.
ENGLISH
Do Not
Warning
Caution
If water is hotter than 185°F is used. If it is broken, property damage,
scalding, and other injuries may occur.
Do not disassemble or modify the item in any way not
described in this manual
Do not
disassemble
If the system is broken, property damage, scalding and other injuries
are likely to occur.
Warning
●The following table demonstrates the use
of safety symbols in this manual.
Absolutely Do NOT.
Do not disassemble
Mandatory!
Less
than185°F
(85° C)
1
Do Not
Caution
Do not strike or kick the product.
If the system is broken, property damage, scalding, and other injuries
may occur.
Do not use the product at temperature exceeding what local
codes allow.
If parts are damaged, property damage, scalding and other injuries may
occur.
Freezing
Page 3
Specification
Water Supply
Pressure
Minimum pressure
Maximum pressure
Supplied Water Temperature
Water Quality
Ambient Temperature
20 psi (0.15MPa)(flowing pressure)
125 psi (0.75MPa)(static)
Less than 185˚F (85˚C)
Water that meet National/Primary drinking water
regulation
34 - 104˚F (2~40˚C)
Water Supply Connection
Humidity
Depending on the model, some specifications may differ.
Before Installation
▪ Observe all local plumbing codes.
▪ Make sure water supply is shut off.
▪ Read these instructions carefully to ensure proper installation.
▪ Check to make sure you have the following parts indicated below.
Check local building
code
1/2” NPT
Maximum 90% RH
ENGLISH
● If the water supply pressure is higher than 125psi (0.86MPa), you should buy a
reducing valve to reduce the pressure to the range of 0.2-0.3MPa (0.2-0.3MPa).
To use the faucet comfortably, the recommended pressure is about 30-45 psi
(0.2-0.3MPa).
●To prevent being scalded due to malfunction, the cold water supply pressure must
be higher than the hot water pressure, or you can make them equal. In addition,
if you increase the pressure of the hot water, it still must be lower than that of cold
water supply side.
●To prevent being scalded due to wrong operation, it is recommended the hot water
supply temperature is 140°F (60°C).
●For ease of water flow adjustment and inspection with tools, you should prepare an
extra stop valve.
2
Page 4
*Some parts may differ from the illustration depending on the model.
Volume
Control
Trims
ENGLISH
Set-Up Drawing
HOT
COLD
Complete Shower Set
Components
6-5/16” (160 mm)
6-5/16” (160 mm)
2-9/16”
65 mm
1/2” NPT
FINISHED
WALL
FINISHED
WALL
2-15/16” (75mm) MIN
3-9/16” (90mm) MAX
Check that you have the following parts.
TS170D
coverplate
escutcheon
handle knob
coverplate
nut
Cap
coverplate
gaasket
Screw
coverplate
TS170C
coverplate
nut
coverplate
escutcheon
handle knob
*Some parts may differ from the figures depending on the model.
3
Cap
coverplate
gaasket
Screw
Owner’s and
Installation manual
TS170C1
coverplate
Cap
gaasket
Screw
Allen Wrech
escutcheon
handle knob
coverplate
nut
Tools you will need
Pipe Tape
Adjustable Wrench
Page 5
Installation Procedure
Some parts differ from the illustration depending on the model and depending on
set up option (Refer to page 5).
Showerhead
(Sold separately)
(Sold separately)
Dual Volume Control
Trim_Hand Shower
(TS170A
)
Dual Volume Control
Valve
(TSKD
)
(Sold separately)
Thermostatic Mixing
Valve Trim
(TS170T
)
TS170A
7-7/8”
(200 mm)
(TS170F
Bath Spout
(Sold separately)
TS170A
(Sold separately)
Single Volume Control
Trim_Hand Shower
(TS170A
)
Dual Volume Control
Valve
(TSKA
)
(Sold separately)
Hand Shower Trim
(handshower and trim)
)
7-7/8”
(200 mm)
55” (1400 mm)
39”(1000 mm)
83” (2100 mm)
ENGLISH
Thermostatic Mixing
Valve
(TSKT
connect valves
1
)
with 1/2” pipe
Install
5
the Trims
Connect Hot/Cold
3
Water Supply Lines
FLOOR
Finish the wall.
4
Refer to the respective manual for
each item for Step 1 to Step 4.
Clean water supply
2
pipes by draining
FLOOR
FINISHED
WALL
23-1/4” (590mm)
4
Page 6
Caution
Leave the guard cover on the valves till the tile work
is completed.
Pull out the guard cover before installing the trims.
Then, clean the tile.
Finished Wall (Tile)
Installation of Volume Control Trims
Volume Control
Valve
guard
cover
①
valve and install coverplate gasket and tighten the nut .
②Confirm that coverplate is firmly installed with the nut.
Then, put on the escutcheon by pushing it into the
ENGLISH
coverplate.
*If the escutcheon is not going in firmly, apply
soft soap on O-ring and try again.
③Confirm that distance between between
top of stem adapter and escutcheon is
1-3/8” (35 mm).
④If not, use the Stem Adjustor provided and
adjust the stem adapter, making sure that
distance is 1-3/8” (35 mm).
⑤Make sure that CONCAVE groove on stem is in the
upward position being in line with CONVEX
groove on handle
⑥Install the handle by using screw and put
the cap on.
Be sure to confirm that the gap is about 1/32” (1 mm).
If the gap is less than 1 mm, lower end of the handle and upper
end of the cover rub against each other, disabling correct operation.
After cleaning the tile, place the coverplate in the
escutcheon
Stem
Adapter
1-3/8”
(35 mm)
Screw
Caution
Coverplate
coverplate
Gasket
O-ring
Escutcheon
Open/Close Tool
Line
Convex
handle
Cap
Line
coverplate nut
stem
adjustor
longer
Stem
escutcheon
handle
1/32”
(1mm)
Stem Adapter
shorter
Stem
Concave
Right above
5
Page 7
Set-Up Options
Showerhead
TS170A#CP
Bath Spout
TS170E#CP
Hand Shower Trim
1) Complete Set
Showerhead
Dual Vol
Control
Trim &
valve
Mixing
Valve Trim
& valve
Bath Spout
Replacement Part
Single Vol
Control Trim
& valve
Handshower
Adapter
Handshower
Trim (Trim &
Handshower)
Product
Description
Single Volume
Control Trim for
Hand Shower
Hand Shower
Dual Volume
Control Trim
2) w/o Handshower
Showerhead
Dual Vol
Control
Trim &
valve
Mixing
Valve Trim
& Valve
Bath Spout
Part
Number
TS170F#CP
TS170C1#CP
Adapter
TS170D#CP
TSKH
3) w/o wall spout
Showerhead
Handshower
Dual Vol
Control
Trim &
valve
Mixing
Valve Trim
& valve
Single Vol
Control
Trim & valve
Handshower
Trim (Trim &
Handshower)
Product
Product
Description
Description
Thermostatic
Mixing Valve Trim
SMA Thermostatic
Mixing Valve
Single Volume
Control Trim for
Head Shower
Single Vol
Control Valve
Dual Volume
Control Valve
Handshower
Adapter
TS170T#CP
TS170C#CP
Part
Number
TSKT
TSKA
TSKD
4) Showerhead only
Showerhead
4
Single
Vol Control
Trim
&
valve
Mixing
Valve Trim
& valve
#CP = Polished Chrome
ENGLISH
No.Description
HANDLE CAP
1
O RING
2
SCREW
3
HANDLE
4
HANDLE RING
5
6
ESCUTCHEON
7
O RING
O RING
COVERPLATE NUT
8
COVERPLATE GASKET
9
COVERPLATE
10
COVERPLATE PACKING
11
(SPECIFY THE MODEL#)
10
9
7
5
8
11
6
2
4
3
1
6
Page 8
Warranty
LIFETIME LIMITED WARRANTY
Warranty applies to selected residential faucets only.
1. TOTO
during normal residential use for as long as the original consumer end-user purchaser owns their home. This
limited lifetime warranty is extended only to the original consumer end-user purchaser and only so long as
the Product remains in use by the original consumer end-user purchaser in its original place of installation in
the purchaser’s residence. This warranty applies only to Product purchased and installed in North America.
2. TOTO® obligations under this warranty are limited to repair or replacement, at TOTO®’s
option, of Product or parts found to be defective in normal residential use, provided that such Product was
properly installed and used in accordance with the owner’s manual. TOTO
inspections as may be necessary in order to determine the cause of the defect.
3. This warranty does not apply to the following items:
Damage or loss sustained in a natural calamity such as
etc.
Damage or loss resulting from any accident, unreasonable use, misuse, abuse, negligence, or improper
care, cleaning or maintenance of the Product.
Damage or loss resulting from sediments or foreign matter contained in a water system.
Damage or loss resulting from improper installation or from installation of the Product in a harsh and/or
hazardous environment, or improper removal, repair or modi cation of the Product.
Damage or loss resulting from the use of an abrasive cleanser.
4. If the Product is used commercially, TOTO
materials and workmanship for one (1) year from the date the Product is installed, with all other terms of this
warranty applicable except the duration of the warranty.
5. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS. YOU MAY HAVE OTHER
RIGHTS, WHICH VARY FROM STATE TO STATE OR PROVINCE TO PROVINCE.
6. To obtain warranty repair service under this warranty, you must take the Product or deliver it prepaid to
a TOTO® service facility with proof of purchase (original sales receipt) together with a letter stating the
problem, or contact a TOTO® distributor or products service contractor, or write directly to TOTO
INC., 1155 Southern road, Morrow, Georgia 30260, (888) 295-8134. If, because of the size of the Product
or nature of the defect, the Product cannot be returned to TOTO®, receipt by TOTO® of written notice of the
defect together with proof of purchase (original sales receipt) shall constitute delivery. In such case, TOTO
may choose to repair the Product at the purchaser’s location or pay to transport the Product to a service
facility.
THIS WRITTEN WARRANTY IS THE ONLY WARRANTY MADE BY TOTO
REPLACEMENT OR OTHER APPROPRIATE ADJUSTMENT AS PROVIDED UNDER THIS
WARRANTY SHALL BE THE EXCLUSIVE REMEDY AVAILABLE TO THE ORIGINAL
PURCHASER. TOTO® SHALL NOT BE RESPONSIBLE FOR LOSS OF THE PRODUCT OR FOR
OTHER INCIDENTAL, SPECIAL OR CONSEQUENTIAL DAMAGES OR EXPENSES INCURRED
BY THE ORIGINAL PURCHASER, OR FOR LABOR OR OTHER COSTS DUE TO INSTALLATION
OR REMOVAL, OR COSTS OF REPAIRS BY OTHERS, OR FOR ANY OTHER EXPENSE NOT
SPECIFICALLY STATED. IN NO EVENT WILL TOTO®’S RESPONSIBILITY EXCEED THE
PURCHASE PRICE OF THE PRODUCT. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE
LAW, ANY IMPLIED WARRANTIES, INCLUDING THAT OF MERCHANTABILITY OR FITNESS
FOR USE OR FOR A PARTICULAR PURPOSE, ARE EXPRESSLY LIMITED TO THE DURATION OF
THIS WARRANTY. SOME STATES AND PROVINCES DO NOT ALLOW LIMITATIONS ON HOW
LONG AN IMPLIED WARRANTY LASTS, OR THE EXCLUSION OR LIMITATION OF INCIDENTAL
OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION AND EXCLUSION MAY NOT
APPLY TO YOU.
®
warrants its faucets (“Product”) to be free from defects in materials and workmanship