THANK YOU FOR CHOOSING TOTO!
Thank you for Choosing TOTO!.......2
Care And Cleaning............................2
Warnings.............................................2
Before Installation..............................2
Tools you will need............................3
Included parts....................................3
Installation Procedure.......................4
Warranty..............................................8
Rough-in dimensions........................30
TABLE OF CONTENTS
WARNINGS
BEFORE INSTALLATION
For safe operation of the shower, please observe the following:
CARE AND CLEANING
2
Your new shower is designed for years of trouble-free performance. Keep it
looking new by cleaning it periodically with mild soap, rinsing thoroughly with
warm water and drying with a clean, soft cloth. Do not use abrasive cleaners,
steel wool or harsh chemicals, as thes will dull the finish. Failure to follow these
instructions may void your warranty.
The mission of TOTO is to provide the world with healthy, hygienic and more
comfortable lifestyles. We design every product with the balance of form and
function as a guiding principle. Congratulations on your choice.
Observe all local plumbing codes.
Before installing the shower, be sure to thoroughly flush the supply pipes of
dirt and debris.
Make sure the water supply is shut off at the stop valve.
Read these instructions carefully to ensure proper installation.
TOTO reserves the right to update product design without notice.
Minimum Pressure....................20 psi (138 kPa), dynamic
Maximum Pressure...................80 psi (551 kPa), static
If you are soldering during installation, do not apply excessive heat to
the valve body. Excessive heat may damage the internal seals and
plastic components.
Please do not use this valve if there is a large difference in the pressure
between the hot and cold water supplies.
Hot water supply temperature should not exceed 140°F (60°C).
Do not use this product at an ambient temperature below 32°F (0°C).
Do not reverse the hot and cold water inlets.
Insulate the hot water supply pipe to minimize heat loss.
Do not use steam for the hot water supply.
Do not disassemble the thermostatic cartridge.
Operating Pressure:
ENGLISH
120°
70°
10°
3
TOOLS YOU WILL NEED
INCLUDED PARTS
Check to make sure you have the following parts indicated below:
ENGLISH
TBV01406 TBV01407 TBV01408
TBV02403 TBV02404TBV02401
Valve body
Temperature
control handle
Diverter handle
Small screw
Handle cap
Screw
Set screw
Lining plate
Trim
Valve body
Lining plate
Trim
Valve body Valve body
Lining plate
Lining plate
Trim
Valve body
Lining plate
Trim
Valve body
Lining plate
Trim
Trim
ScrewdriverHacksaw Thermometer Silicon caulk
Hex wrench
(4mm)
(2.5mm)
(not included for TBV01406, TBV02401)