TotalPond UW16257 User Manual
PACKAGE CONTENTS
Questions, pr
oblems, missing parts?
C
B
A
ITEM # UW16257
Decorative Floating Lights
REMINDER
CALL 1-888-412-6001
BEFORE RETURNING TO STORE.
Part Description Quantity
A Lights 1
B Sensor 1
C Transformer 1
retailer, call our customer service department at
1-888-412-6001, 8 a.m.-6 p.m., EST, Monday-Friday, or email
us at customercare@totalpond.com. Or visit our website
www.totalpond.com.
Before returning to your
WARNINGS AND CAUTIONS
WARNING
• To reduce the risk of electrical shock, connect only to a properly grounded, grounding type receptacle.
• Do not exceed the voltage shown on the transformer.
• Do not submerge the transformer and sensor.
• To reduce the risk of fire or injury, keep lamp away from materials that may burn.
• Always disconnect light from the power source before beginning any maintenance or work on the light.
• Inspect cord for damage before installation and/or maintenance. Replace the entire light/transformer
assembly if damage is found.
CAUTION
• Use a proper power source as indicated on the transformer label.
• Keep the cord away from high temperatures or other heat sources.
• Do not lift the light or the transformer by its power cord.
• This light assembly is not intended for use in swimming pools or hot tubs.
1
PREPARATION
Before beginning assembly or operation of product, make sure all parts are present. Compare parts with
ASSEMBLY INSTRUCTIONS
Sensor
package contents list and diagram above. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
• Estimated Assembly Time: 5 minutes
• Tools required for assembly: Shovel.
These lights can be placed in or out of the water. For installation in the water, proceed to step 1. For
installation outside of the water, proceed to step 2.
1. Place the lights in the water. Anchoring the lights using string
and a weight is recommended. Fig. 1
NOTE: String and the weight are NOT INCLUDED.
Fig. 1
2. Dig three holes approximately 3 inches deep. Place the lights
in the holes then bury the stakes. Fig. 2
NOTE: Do not push down on the lights when installing in the
ground. The lights are made of glass and can break if not
installed correctly.
Fig. 2
3. Make sure that the transformer and sensor are NOT
submerged. Make sure that the light sensor faces up. Fig. 3
NOTE: At night, the lights will automatically turn on.
At sunrise, they will automatically turn off.
Lights
(Must face up)
2
Fig. 3
Loading...