TotalPond PF1200UV User Manual
PACKAGE CONTENTS
Questions, problems, missing parts?
ITEM # PF1200UV
Pressurized Filter
Up to 1200 gallons
REMINDER
CALL 1-888-412-6001
BEFORE RETURNING TO STORE.
Part Description Quantity
A Tank 1
B Cover 1
C Lid 1
D O-ring 1
E Adapter 2
F Gasket 4
G Small gasket 2
H Locking ring 4
I Bio media balls 12
J Coarse filter 1
K Fine filter 1
L Small adapter 2
M Tubing 1
N UV clarifier 1
O UV bulb 1
to your retailer, call our customer service department at
1-888-412-6001, 8 a.m.-6 p.m., EST, Monday-Friday, or
email us at customercare@geoglobalpartners.com. Or
visit our website www.totalpond.com.
Before returning
C
B
D
A
E
M
L
I
J
K
F
H
G
N
O
WARNINGS AND CAUTIONS
WARNING
• WARNING – Improper connection of the appliance-grounding conductor can result in a risk of electric
shock. Check with a qualified electrician or service representative if you are in doubt whether the
appliance is properly grounded. Do not modify the plug provided with the appliance; if it will not fit the
outlet, have a proper outlet installed by a qualified technician.
• Do not operate any appliance if it has a damaged cord or plug, or if it is malfunctioning or if it is
damaged in any manner.
• Always unplug the appliance from the outlet before putting on or taking off parts, before cleaning or
when not in use.
• Connect only to a circuit that is protected by a ground-fault circuit-interrupter (GFCI).
• Risk of Electric Shock - Do not use the UV filter if the quartz tubing around the lamp is broken.
Immediately unplug and seek an authorized repair service or discard the unit.
• GROUNDING INSTRUCTIONS – This appliance must be grounded. In the event of a malfunction or
breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for
electric current. This appliance is equipped with a cord having an appliance-grounding conductor and a
1
grounding plug. The plug must be plugged into an appropriate outlet that is installed and grounded in
IMPORTANT NOTES
PREPARATION
accordance with all local codes and ordinances.
CAUTION
• UV light may cause irritation to the skin and/or eyes. Avoid exposure.
• DANGER – ULTRAVIOLET RADIATION – Diconnect Power Before Replacing Lamp.
• Prolonged or repeated exposure to UV light may have adverse physical effects including, severe
damage to your skin and eyes. Seek immediate medical attention for overexposure to UV radiation.
• Keep the cord away from high temperatures or other heat sources.
• Do not lift the light or the transformer by its power cord.
• This light assembly has not been investigated for use in swimming pools or hot tubs.
• This product is designed to prohibit its operation unless it is fully assembled with the lamp base
screwed completely into the housing.
•
UV rays are harmful to your eyes and skin. The indicator portal will remove the harmful effects of the UV
light but still allow you to see the bulb operating.
• Do not attempt to operate this product unless the lamp is completely assembled within the light
housing.
• This product conforms to the Code of Federal Regulations (CFR) requirements including, Title 21,
Chapter 1, Subchapter J, Radiological Health.
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and diagram above. If any part is missing or damaged, do not attempt to assemble, install or
operate the product. Contact customer service for replacement parts.
• Estimated Assembly Time: 20 minutes
• Tools required for assembly: hacksaw.
Lamp Voltage 60V
Lamp Current 0.2A
Lamp Power 9 W
Rated Frequency 60 Hz
UV Irradiance 35 µW/cm2
Bulb Life 8000 hours
Bulb Model Number UVRB
UV Wave Length UV(C) · 254 nm
Specifications
2
ASSEMBLY INSTRUCTIONS
1. Assemble the locking ring, adapter and gasket.
Fig. 1
Fig. 1
2. Place the bio-balls inside the filter. Fig. 2
Fig. 2
3. Place the fine filter pad inside the tank. Then place the coarse
filter pad over the fine filter pad. Fig. 3
NOTE: The coarse filter pad is black. The fine filter pad is
blue.
Fig. 3
A
F
H
E
J
K
3
Loading...