TotalPond MD11400ASL User Manual
PACKAGE CONTENTS
B
A
D
Questions, problems, missing parts?
C
ITEM # MD11400ASL
Low-Water Auto Shutoff Pump with
Light
400 Gallons Per Hour
REMINDER
CALL 1-888-412-6001
BEFORE RETURNING TO STORE.
Part Description Quantity
A Pump 1
B Light 1
C 1/2-in. tubing adapter 1
D 5/8-in. tubing adapter 1
retailer, call our customer service department at
1-888-412-6001, 8 a.m.-6 p.m., EST, Monday-Friday, or email
us at customercare@geoglobalpartners.com. Or visit our
website www.totalpond.com.
Before returning to your
WARNINGS AND CAUTIONS
WARNING
• Risk of electrical shock. This pump is supplied with a grounding conductor and grounding–type
attachment plug. To reduce the risk of electric shock, be certain that it is connected only to a properly
grounded, grounding- type receptacle (GFCI).
• Do not exceed the voltage shown on the pump.
• Always disconnect pump from the power source before beginning any maintenance or work on the
pump.
• Inspect cord for damage before installation and/or maintenance. Replace the entire pump assembly if
damage is found.
• Do not remove the grounding pin from the power cord plug.
• To reduce the risk of electric shock, use only on portable, self-contained fountains no larger than 5 ft. in
any dimension.
• Risk of electrical shock – This pump has not been investigated for use in swimming pool or marine
areas.
1
CAUTION
PREPARATION
ASSEMBLY INSTRUCTIONS
Plug from
light
from
pump
• This pump has been evaluated for use with fresh water only.
• Use a proper power source as indicated on the pump label.
• Keep the cord away from high temperatures or other heat sources.
• Do not pump heated liquids.
• Do not let the pump run dry. Pump must be completely submerged for proper operation and cooling.
• Operate in freshwater only. Avoid heavily chlorinated water and water with high pH levels.
• Do not lift the pump by its power cord.
Before beginning assembly or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram above. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
• Estimated Assembly Time: 5 minutes
• No tools required for assembly.
1. Connect tubing to the outlet of the pump with the appropriate
adapter. Fig 1
NOTE: Tubing is NOT INCLUDED.
Fig. 1
2. Connect the light to the pump by pushing the plug into the socket
until it is firmly seated. Hand tighten the nut from the plug to the
Socket
socket. Fig. 2
Fig. 2
3. Place the pump into the water and connect to a proper power
source. Adjust flow control as required. Fig. 3
GFCI
Fig. 3
2
Loading...