TotalPond LL3600 User Manual
PACKAGE CONTENTS
Ques
tions, problems, missing parts?
A
B C
ITEM # LL3600
Submersible Waterfall Pump
3600 Gallons Per Hour
REMINDER
CALL 1-888-412-6001
BEFORE RETURNING TO STORE.
Part Description Quantity
A Pump 1
B
C pump barrier bag 1
WARNINGS AND CAUTIONS
WARNING
• Risk of electrical shock. This pump is supplied with a grounding conductor and grounding–type
attachment plug. To reduce the risk of electric shock, be certain that it is connected only to a properly
grounded, grounding-type receptacle.
• Do not exceed the voltage shown on the pump.
• Always disconnect pump from the power source before beginning any maintenance or work on the
pump.
• Inspect cord for damage before installation and/or maintenance. Replace the entire pump assembly if
damage is found.
• Do not remove the grounding pin from the power cord plug.
• Risk of electrical shock: This pump has not been investigated for use in swimming pools or marine
areas.
CAUTION
• This pump has been evaluated for use with water only.
• Use a proper power source as indicated on the pump label.
• Keep the cord away from high temperatures or other heat sources.
• Do not pump heated liquids.
• Do not let the pump run dry. Pump must be completely submerged for proper operation and cooling.
• Operate in fresh water only. Avoid heavily chlorinated water and water with high pH levels.
• Do not lift the pump by its power cord.
1-1/2 in. and 2 in. ID tubing
adapter
to your retailer, call our customer service department at
1-888-412-6001, 8 a.m.-6 p.m., EST, Monday-Friday, or
email us at customercare@geoglobalpartners.com. Or
visit our website www.totalpond.com.
1
Before returning
1
PREPARATION
Before beginning assembly or operation of product, make sure all parts are present. Compare parts with
OPERATION INSTRUCTIONS
package contents list and diagram above. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
• Estimated Assembly Time: 5 minutes
• Tools required for assembly: hacksaw.
1. For maximum water flow, it is recommended that the largest
tubing size for your pump is used. If using 1-1/2 in. ID tubing,
proceed to step 2. If using 2 in. ID tubing, cut the adapter as
shown using a hacksaw. Fig. 1
Cut ring
Fig. 1
2. Connect tubing to the outlet of the pump using an adapter.
Fig. 2
Tubing
NOTE: Tubing is NOT INCLUDED.
Adapter
Pump
Fig. 2
3. Place the pump inside the pump barrier bag. Pull the
drawstring until the pump barrier bag is fully closed around
the tubing and power cord. Tie a knot in the drawstring.
Fig. 3
Fig. 3
4. Place the pump into the water and connect to a proper power
source. Fig. 4
GFCI
Fig. 4
2
Loading...