Page 1
Questions, problems, missing parts?
A
B
C
ITEM # LL2000
Submersible Waterfall Pump
2000 Gallons Per Hour
REMINDER
CALL 1-888-412-6001
BEFORE RETURNING TO STORE.
PACKAGE CONTENTS
Part Description Quantity
A Pump 1
B
C Pump barrier bag 1
WARNINGS AND CAUTIONS
1 in. and 1-1/2 in. ID tubing
adapter
to your retailer, call our customer service department at
1-888-412-6001, 8 a.m.-6 p.m., EST, Monday-Friday, or
email us at customercare@geoglobalpartners.com. Or
visit our website www.totalpond.com.
1
Before returning
WARNING
• Risk of electrical shock. This pump is supplied with a grounding conductor and grounding–type
attachment plug. To reduce the risk of electric shock, be certain that it is connected only to a properly
grounded, grounding-type receptacle.
• Do not exceed the voltage shown on the pump.
• Always disconnect pump from the power source before beginning any maintenance or work on the
pump.
• Inspect cord for damage before installation and/or maintenance. Replace the entire pump assembly if
damage is found.
• Do not remove the grounding pin from the power cord plug.
• Risk of electrical shock: This pump has not been investigated for use in swimming pools or marine
areas.
CAUTION
• This pump has been evaluated for use with water only.
• Use a proper power source as indicated on the pump label.
• Keep the cord away from high temperatures or other heat sources.
• Do not pump heated liquids.
• Do not let the pump run dry. Pump must be completely submerged for proper operation and cooling.
• Operate in fresh water only. Avoid heavily chlorinated water and water with high pH levels.
• Do not lift the pump by its power cord.
1
Page 2
PREPARATION
Before beginning assembly or operation of product, make sure all parts are present. Compare parts with
OPERATION INSTRUCTIONS
package contents list and diagram above. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
• Estimated Assembly Time: 5 minutes
• Tools required for assembly: hacksaw.
1. For maximum water flow, it is recommended that the largest
tubing size for your pump is used. If using 1 in. ID tubing,
proceed to step 2. If using 1-1/2 in. ID tubing, cut the adapter as
shown using a hacksaw. Fig. 1
Cut ring
Fig. 1
2. Connect tubing to the outlet of the pump using an adapter.
Fig. 2
Tubing
NOTE: Tubing is NOT INCLUDED.
Adapter
Pump
Fig. 2
3. Place the pump inside the pump barrier bag. Pull the drawstring
until the pump barrier bag is fully closed around the tubing and
power cord. Tie a knot in the drawstring. Fig. 3
Fig. 3
4. Place the pump into the water and connect to a proper power
source. Fig. 4
GFCI
Fig. 4
2
Page 3
CARE AND MAINTENANCE
• Clean the pump barrier bag and (if necessary the pump) regularly depending upon the environment
TROUBLESH
OOTING
REPLACEMENT PARTS LIST
B
D
G
in which it is operated. A drop in water flow is an indication that your pump barrier bag and/or pump
require cleaning. The pump barrier bag not only protects your pump but significantly reduces the
need for pump maintenance.
• Before cleaning, always disconnect the pump from the power source.
• Remove any large debris from pump barrier bag. Use a garden hose to rinse off any other dirt
from the pump barrier bag.
• Remove all parts from the pump and clean in warm, soapy water.
• Disassemble the screen and remove the impeller housing to expose the impeller assembly.
Remove the impeller assembly by pulling on the back round plate behind the impeller.
• Use a soft cloth or brush to clean the impeller assembly and the inside of the impeller housing.
Refer to the diagram in the replacement parts list.
If the pump fails to operate:
• Check to make sure the power cord is plugged in and the pump is getting power.
• Check the pump outlet and any tubing, fountains, spitters, etc., for kinks or obstructions.
• Remove the inlet screen and/or pump cover, and impeller housing to expose the impeller. Turn
the impeller to ensure that it is not broken or jammed. Also check to make sure that the
ceramic shaft or bearings are not broken.
If the performance of the pump is not satisfactory or the pump does not flow evenly:
• Check to make sure the pump is completely submerged in water.
• Check to make sure the impeller and the housing are clean.
• Check to make sure the pump barrier bag is clean.
For replacement parts, call our customer service department at 1-888-412-6001, 8 a.m.-6 p.m., EST,
Monday-Friday.
Part Description
B 1 in. and 1-1/2 in. ID tubing adapter
C Pump barrier bag
D Impeller housing
E O-ring
F Impeller Assembly
G Screen
F
C
E
3
Page 4
PUMP PERFORMANCE
LIFT / Elevación (feet)
Flow Rates/Flujo (GPH)
16
15
14
13
12
11
10
9 824 1509 2230 3600
8 914 1610 2380 3800
7 1017 1686 2547 4000
6 1136 1762 2719 4200
5 1242 1893 2832 4400
4 1353 2048 2996 4600
3 1464 2206 3194 4724
2 1596 2367 3387 4900
1 1709 2536 3560 5019
0 1823 2658 3810 5083
600 1041 1680 3100
676 1125 1806 3300
742 1268 2034 3418
LL1200 LL2000 LL3600 LL5100
823 1300 2900
955 1489 3059
Waterfall Pumps/ Bombas para Cascada
1000 2500
1168 2700
Printed in China
4
Page 5
LIMITED WARRANTY
All pumps and electrical products are warranted to the user against defective material and workmanship,
under normal working conditions. This warranty period begins on the date of purchase by the original
purchaser.
All TotalPond® electrical products are warranted to the user against defective material and workmanship,
under normal working conditions for 1 year from the date of purchase. All TotalPond® liners are warranted
to the user against defective workmanship, under normal working conditions for 20 years from the date of
purchase. All other TotalPond® product is warranted to the user against defective material and
workmanship, under normal working conditions for 90 days.
Application
Warranty covers only properly installed and maintained units. Pump warranty is limited to applications
pumping fresh water in a pond or fountain only. Other liquid applications or extreme temperature uses
must be approved in writing by the manufacturer. Receipt and product date code are required for warranty
claims.
Warranty Claim
Warranty claims must be made by calling customer service (at 1-888-412-6001). If the item is
determined to be defective, you will be given authorization to return the defective part(s), freight pre-paid,
along with proof of purchase.
Disposition
The manufacturer will make a good faith effort for prompt disposition regarding all warranty claims.
Returned product will be inspected to determine cause of failure before warranty is applied. Warranty does
not cover any costs associated with the shipping, handling, installation or removal of products or parts
subject to this warranty. For products damaged in transit, a claim should be filed with the carrier.
Disclaimer
Any oral statements made about the product by the seller, the manufacturer, the representatives, or any
other parties do not constitute warranties, should not be relied upon by the user, and are not part of the
contract for sale. The seller’s and manufacturer’s only obligation, and buyer’s only remedy shall be for the
manufacturer to either replace and/or repair at the manufacturer’s sole discretion, the product as described
above. Neither seller nor the manufacturer shall be liable for injury, loss or damages for lost profits, lost
sales, injury to person or property, or any other incidental or consequential loss arising from any cause
whatsoever, no matter whether based upon warranty, contract, negligence or other misuse, and the buyer
and user agree that no other remedy shall be available to them. Before using, the buyer and user shall
determine the suitability of the product for the intended use, and assume all risk and liability whatsoever in
connection therewith. The warranty and remedy described in this limited warranty is an exclusive warranty
and remedy in lieu of any other warranty or remedy expressed or implied. All other warranties and
remedies are hereby expressly excluded, including but not limited to any implied warranty of
merchantability of fitness for any particular purpose. This warranty gives the buyer and user specific legal
rights, and buyer and user may also have other rights which vary from state to state. Some states do not
allow exclusions or limitations of incidental or consequential damages, so the above limitations or
exclusions may not apply to you.
REMINDER
CALL 1-888-412-6001
BEFORE RETURNING TO STORE.
5
Loading...