TotalPond DD11560 User Manual
PACKAGE CONTENTS
Questions, problems, missing parts?
ITEM # DD11560
Submersible Pond Pump
560 Gallons Per Hour
REMINDER
CALL 1-888-412-6001
BEFORE RETURNING TO STORE.
Part Description Quantity
A Pump 1
B Inlet screen 1
C Flow control 1
WARNINGS AND CAUTIONS
WARNING
• Risk of electrical shock. This pump is supplied with a grounding conductor and grounding–type
attachment plug. To reduce the risk of electric shock, be certain that it is connected only to a properly
grounded, grounding-type receptacle.
• Do not exceed the voltage shown on the pump.
• Always disconnect pump from the power source before beginning any maintenance or work on the
pump.
• Inspect cord for damage before installation and/or maintenance. Replace the entire pump assembly if
damage is found.
• Do not remove the grounding pin from the power cord plug.
• To reduce the risk of electric shock, use only on portable, self-contained fountains no larger than 5 ft. in
any dimension.
• Risk of electrical shock – This pump has not been investigated for use in swimming pools or marine
areas.
CAUTION
• This pump has been evaluated for use with fresh water only.
• Use a proper power source as indicated on the pump label.
• Keep the cord away from high temperatures or other heat sources.
• Do not pump heated liquids.
• Do not let the pump run dry. Pump must be completely submerged for proper operation and cooling.
• Operate in fresh water only. Avoid heavily chlorinated water and water with high pH levels.
• Do not lift the pump by its power cord.
to your retailer, call our customer service department at
1-888-412-6001, 8 a.m.-6 p.m., EST, Monday-Friday, or
email us at customercare@geoglobalpartners.com. Or
visit our website www.totalpond.com.
C
B
Before returning
A
1
PREPARATION
Before beginning assembly or operation of product, make sure all parts are present. Compare parts with
OPERATION INSTRUCTIONS
CARE AND MAINTENANCE
TROUBLESHOOTING
package contents list and diagram above. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
• Estimated Assembly Time: 5 minutes
• No tools required for assembly.
1. Screw the inlet screen to the intake of the pump, and then connect
tubing to the outlet of the pump with flow control.
Tubing
Fig. 1
NOTE: Tubing is NOT INCLUDED.
Flow control
Inlet screen
Pump
Fig. 1
2. Place the pump into the water and connect to a proper power
source. Fig. 2
GFCI
Fig. 2
• Regular cleaning of the pump may be necessary depending upon the environment in which it is
operated. Clean the pump when it is visibly soiled or when a drop in performance is detected.
• Before cleaning, always disconnect the pump from the power source.
• Remove all parts from the pump and clean in warm, soapy water.
• Disassemble the inlet screen and/or pump cover, and remove the impeller housing to expose the
impeller assembly. Use a soft cloth or brush to clean the impeller assembly and the inside of the
impeller housing. Refer to the diagram in the replacement parts list.
If the pump fails to operate:
• Check to make sure the power cord is plugged in and the pump is getting power.
• Check the pump outlet and any tubing, fountains, spitters etc. for kinks or obstructions.
• Remove the inlet screen and/or pump cover, and impeller housing to expose the impeller. Turn
the impeller to ensure that it is not broken or jammed.
If the performance of the pump is not satisfactory or the pump does not flow evenly:
• Check to make sure the pump is completely submerged in water.
• Check to make sure the impeller and the housing are clean.
• Adjust flow control.
2
Loading...