TotalPond A16549 User Manual

PACKAGE CONTENTS

Questions, problems, missing parts?

D

ITEM # A16549

Pond Aerator with Lights

REMINDER

CALL 1-888-412-6001

BEFORE RETURNING TO STORE.

Part Description Quantity

A Aerator 1
B Lily pad w/ air valve 1
C Artificial plant life 8
D Anchor 1

B

C

retailer, call our customer service department at
1-888-412-6001, 8 a.m.-6 p.m., EST, Monday-Friday, or email
us at [e-mail]. Or visit our
website www.totalpond.com.

Before returning to your

A

WARNINGS AND CAUTIONS

WARNING

• Risk of electrical shock. This aerator is supplied with a grounding conductor and grounding–type
attachment plug. To reduce the risk of electric shock, be certain that it is connected only to a properly
grounded, grounding-type receptacle (GFCI).

• Do not exceed the voltage shown on the aerator.

• Always disconnect aerator from the power source before beginning any maintenance or work on the

aerator.

• Inspect cord for damage before installation and/or maintenance. Replace the entire aerator assembly if
damage is found.

• Do not remove the grounding pin from the power cord plug.

• Risk of electrical shock: This aerator has not been investigated for use in swimming pools or marine

areas.

CAUTION

• This aerator has been evaluated for use with water only.

• Use a proper power source as indicated on the aerator label.

• Keep the cord away from high temperatures or other heat sources.

• Do not pump heated liquids.

• Do not let the aerator run dry. Aerator must be completely submerged for proper operation and cooling.

• Operate in fresh water only. Avoid heavily chlorinated water and water with high pH levels.

• Do not lift the aerator by its power cord.

1

PREPARATION

Before beginning assembly or operation of product, make sure all parts are present. Compare parts with

OPERATION INSTRUCTIONS

package contents list and diagram above. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.

• Estimated Assembly Time: 5 minutes

• Tools Required for Assembly: no tools required.

1. If desired, attach the artificial plant life to the cover of the aerator.

Fig. 1

Fig. 1

2. Connect the air hose to the air valve. Note that the air valve is

connected to the lily pad. Fig. 2

Fig. 2

3. Tie the anchor to the air hose. This will prevent the air hose from

floating to the surface during operation. Fig. 3

Fig. 3

2

4. Place the aerator in the water. Be sure that the air valve and lily pad

stay above the water level. Fig. 4

5. Connect the pump to a proper power source. Fig. 5

6. Adjust the valve to control the amount of bubbles coming out of the

aerator. For more bubbles, turn counterclockwise. For less
bubbles, turn clockwise. Fig. 6

Fig. 4

GFCI

Fig. 5

For more bubbles

Turn counterclockwise

For less bubbles

Turn clockwise

Fig. 6

3