TotalPond A16531L User Manual

A16531L

PACKAGE CONTENTS

E

E

G

J

Questions, problems, missing parts?

Container Fountain Kit with LED
Light

REMINDER

CALL 1-888-412-6001

BEFORE RETURNING TO STORE.

Part Description Quantity

A Pump with filter and LED light 1
B Extensions 4
C Extension tubes 1
D Waterspray nozzle 1
E Waterbell nozzle insert 1
F Trumpet nozzle insert 1
G Lower fountain head nozzle 1
H Epoxy putty (part A) 1

I Epoxy putty (part B) 1

J Cord holder 1

C

D

F

retailer, call our customer service department at
1-888-412-6001, 8 a.m.-6 p.m., EST, Monday-Friday, or email
us at [e-mail]. Or visit our website
www.totalpond.com.

ITEM #

Before returning to your

H

I

A

B

WARNINGS AND CAUTIONS

WARNING

• Risk of electrical shock. This pump is supplied with a grounding conductor and grounding–type
attachment plug. To reduce the risk of electric shock, be certain that it is connected only to a properly
grounded, grounding-type receptacle.

• Do not exceed the voltage shown on the pump.

• Always disconnect pump from the power source before beginning any maintenance or work on the

pump.

• Inspect cord for damage before installation and/or maintenance. Replace the entire pump assembly if
damage is found.

• Do not remove the grounding pin from the power cord plug.

• To reduce the risk of electric shock, use only on portable, self-contained fountains no larger than 5 ft. in

any dimension.

• Risk of electrical shock – This pump has not been investigated for use in swimming pools or marine

OPERATION

INSTRUCTIONS

D

CC C

G

F

GE

areas.

CAUTION

• This pump has been evaluated for use with water only.

• Use a proper power source as indicated on the pump label.

• Keep the cord away from high temperatures or other heat sources.

• Do not pump heated liquids.

• Do not let the pump run dry. Pump must be completely submerged for proper operation and cooling.

• Operate in freshwater only. Avoid heavily chlorinated water and water with high pH levels.

• Do not lift the pump by its power cord.

PREPARATION

Before beginning assembly or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram above. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.

• Estimated Assembly Time: 30 minutes

• Tools required for assembly: container, plastic liner or sealant, drill, 1-1/4” drill bit, silicone caulk, latex

gloves.

1. Connect the extension tubes to the pump. Fig. 1

Fig. 1

2. Choose a fountain head for the desired water effect, and assemble

your choice as shown in Fig. 2.

Fig. 2

3. Choose a container for your fountain kit. Fig. 3

Liner

Cord

Fig. 3

4. If the container is not already watertight, use a plastic liner. Or if a

clay pot is used, spray the inside of the pot with a clear acrylic
sealant. Be sure to use a sealant that is safe for clay pots. Wait 24
hours for the sealant to dry before filling the container with water.
Fig. 4

Fig. 4

5. Test fit the assembled container fountain kit in the container. For

installing the fountain with the pump cord over the side of the
container (recommended), proceed to step 9. For having the pump
cord comes out through the container wall, proceed to the next
step. Fig. 5

Fig. 5

6. Select a spot on the container wall that is the least visible from

normal viewing for the cord exit. Drill a hole in appropriate 1 1/4 in.
diameter. Fig. 6

NOTE: Appropriate safety equipment should be used.

Fig. 6