Tosot TFM125-9K, TFM125-12K, TFM125-15K Owner's Manual

Page 1
Thanks for choose our product. Please, read carefully this manual before using the equipment.
AIR CURTAIN
OWNER’S MANUAL
TFM125-9K, TFM125-12K, TFM125-15K
Page 2
-2--1-
The air of indoor sucked in by the cross ow fan of the air curtain, blown down to the oor at a high
speed. And the downward airow formed an invisible“wall”.
The air curtain is usually installed on the upside of the door the window, when the door or the window
is opened, the airow of the air curtain could isolate the air of the indoor side and outdoor side effectively.
Thus the cool air leaking of the indoor side can be reduced, and can prevent the mosquitoes and dust from
entering into the room as well.
The length of air curtain should be consonance with the width of the door or the window, put two sets
of unit or more side by side to cover the width of the door or window entirely.
In order to obtain more effective efciency, the air outer of the air curtain should be paralleled with the
door head, ensure that the speed of airow which arrived at the oor should be more than 2.5meters/sec.
2 Specication
Model
Length
(mm)
Diameter of
impeller(mm)
Power supply
Power
input(W)
Noise
dB(A)
Weigh
(kg)
W×D×H
(mm×mm×mm)
TFM125-9K
900 125
220-240V~ 50Hz/60Hz
110 59 16 900×206×215
TFM125-12K
1200 125
220-240V~ 50Hz/60Hz
140 61 20 1200×206×215
TFM125-15K
1500 125
220-240V~ 50Hz/60Hz
180 61 25 1500 X206X215
3 Installation
The installing location should be rm enough, free of vibration. The unit cannot be installed in the damp
or the water-leaking place and should avoid the directly lighting of sunlight.
Installation method:
(1) Take out the wall-mounted frame, put it attach to the wall, to conrm the installation position of the
bolt hole and to make the mark on it.
(2) To drill the expansion bolt hole on the marked position.
(3) To x the wall-mounted frame on the wall with 8pcs M10 expansion bolt, the installation must be
rm and reliable.
(4) Hang the unit on the wall-mounted frame, and screw down the 4pcs bolt under the unit.
(5) To check whether the unit is well installed, the body level and pluged in.
(6) The dimension diagram for hole position of wall-mounted frame was shown in below (Unit:mm):
Model A B C
TFM125-9K
160 800 870
TFM125-12K
160 1100 1170
TFM125-15K
160 1400 1470
Notes:
(1) Please install unit on the indoor side.
(2) Do not install or use the unit in place where:
1) Freezing may occur.
2) Steam is produced.
3) Remarkable dust is produced.
4) Oil smoke is produced.
5) Explosive dust or gas exist.
6) Corrosive gas is produced.
7) It is splashed by water.
(3) Please install the unit horizontally, make the air outlet downward vertically.
(4) Install the unit in sturdy place free of vibration.
(5) In order to prevent accident of electric shock, make sure that earthed well.
(6) Provide an electric leakage breaker and air-break switch should be installed at the power supply
side.
(7) The Air Curtain is to be installed so that the blades are more than 2.3m above the oor.
(8) The place where the AIR CURTAIN is to be installed must be taken to avoid the black ow of gases
into the room from the open ue of gas or other fuel-burning appliance.
(9) It is necessary to have the plug accessible after installation.
(10) The minimum distance between the various parts of the appliance and the surrounding structure is
300mm.
4 Circuit diagram
Power:220-230V~ 50/60Hz
L N PE
BN(BK)
BU(WH)
YE/GN(GN)
AC-L
AC-N
FAN-H
FAN-L
AC-N
YE/GN
BU
AP1
BN
RD
AP2
C
E
FAN MOTOR
WH
CN1
CN1
CN3
CN2
BK
TC
POWER TRANSFORMER
Air Curtain Owner's Manual
Page 3
-3-
5 Trial running and troubleshooting
When plugged in, to press the ON/OFF button of the control panel, the unit will run at high-speed.
When pressing the HI or LOW button of the control panel, the unit will be switched over from the high-
speed running to the low-speed running. When pressing the ON/OFF button of the wireless remote control,
the unit will be switched over from the high-speed running to the low-speed running.
If the unit can not operated, please check below.
1) Whether the power supply is well connected.
2) Whether the batteries of wireless remote control has electricity, if not please replace the batteries.
6 Maintenance
If the supply cord is damaged, it must be replaced by the manufacture, its service agent or similarly
qualied persons in order to avoid a hazard.
When cleaning the unit, make sure to pull the plug out. Please wipe the body by soft cloth, clean the
unit inside by the vacuum cleaner. Add oil to lubricate the bearing of the fan motor once a year at least.
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
Page 4
(+34) 93 390 42 20 (+34) 93 390 42 05
info@tosot.es
www.tosot.es
Industria, nº13
Polígono Industrial El Pedregar
08160 Montmeló Barcelona (Spain)
Phone:
Fax:
Loading...