Toshiba T-Series T5100, T-Series T5100 PA8040U, T-Series T5100 PA8041U Specifications
T5100
(No longer manufactured)
General Information
Model number: T5100 40MB - PA8040U (FCC ID# CJ69XAE349)
T5100 100MB - PA8041U (FCC ID# CJ69XAE573)
Dimensions: 12.2" W x 14.2" D x 3.6"H
Weight: 14.6 lbs.
Voltage: 115VAC , 1.0A/220 - 240VAC, 0.7A auto sensing
Frequency: 50/60Hz auto sensing
CPU: 80386-16 (16/8MHz); 80387-16 coprocessor socket
RAM memory: 2MB standard (640K Conventional; 1.384MB LIM-EMS 3.2 or extended memory)
Memory expandable to 4MB when optional 2MB memory card added
Video RAM: 256KB
Number of keys: 82
Keyboard type: Selectable between 84 or 101-key keyboard compatible
Drives: One 1.44 MB 3.5" floppy disk drive
One 40 MB or one 100MB hard disk drive
Operating system included: Toshiba MS-DOS 3.30 or 4.01
Software Compatibility
Compatible with software written for the IBM PC/XT/AT using EGA, CGA, or T3100/AT&T 6300 640 x 400 high resolution
graphics mode
Interfaces
RGB Color Video port (EGA or CGA)
RS-232-C serial port
Parallel printer/external diskette or tape drive port
101-key enhanced keyboard port
Toshiba proprietary memory slot
Toshiba proprietary expansion slot - "A" form factor
Orange Gas Plasma Display
Display area: 7.5"W x 5.7"H; 9.5" diagonal
Resolution: 640 x 400
Gray scales: 4
Contrast: 10 : 1
3.5" 40MB Hard Disk Drive
Conner Peripherals HDD: CP-342
Interface: IDE
Average access time: 29 ms
Recording method: 2-7 RLL
TEST3 setup type: 6
or
Conner Peripherals HDD: CP-3044
Interface: IDE
Average access time: 25ms
Recording method: 2-7 RLL
TEST3 setup type: 7
Toshiba America Inf ormation Systems I nc. ("TAIS") shall not be li abl e f or damages of any kind for use of thi s information, which is subject to
change without notice. Copyright 1994 TAIS. 5100.DOC Rev. 1 06/02/94 MQC/nmm.
Page 5
T5100
(continued)
3.5" 100MB Hard Disk Drive
Conner Peripherals HDD: CP-30104
Interface: IDE
Average access time: 25ms
Recording method: 2 - 7 RLL
TEST3 setup type: 9
Soft Switches
1) Change CPU speed
Fn + PgUp 16MHz CPU speed
Fn + PgDn 8MHz CPU speed
2) Character font
Fn + Right arrow Toggles display font
3) Display select
Fn + End External display
Fn + Home Plasma display
4) Extending the display area
Fn + Down arrow Toggles between 350 and 400 rows in EGA mode
5) Keypad overlay
Fn + NumLock Toggles keyboard overlay
6) Fn key
Fn + F1 F11
Fn + F2 F12
Fn + Ctrl Simulate IBM enhanced keyboard Right Ctrl
Fn + Alt Simulate IBM enhanced keyboard Right Alt
Fn + Enter Simulate IBM enhanced keyboard numeric keypad Enter
Fn + power on Force T5100 to CMOS setup screen
Hardware Switches and Controls
1) Power on/off
Located on back of computer
2) A/B/PRT switch
Located on left side of computer
With switch set to "A", external FDD port is accessed as drive A; internal 3.5" FDD as drive B.
With switch set to "B", external FDD port is accessed as drive B; internal 3.5" FDD as drive A.
Switch is set to "PRT" for parallel printer output.
Computer must be re-booted for switch change to take effect.
3) Plasma display brightness and contrast dials
Located on front of display
4) 6 DIP switch bank
Located on back of computer
Factory default settings all off (off=down)
SW1 OFF Expanded or Extended ON Expanded Memory Only
Memory enabled Disables Extended Memory
SW2 OFF 640K Base Memory ON 512K Base Memory
SW3 OFF Enable Internal video controller ON Disable Internal video controller
SW4 OFF PRT Output Only ON PRT Bidirectional
SW5 OFF Normally off ON For use with ISC UNIX
SW6 OFF Serial Port COM 1 ON Serial Port COM 2
T5100
(continued)
Toshiba America Inf ormation Systems I nc. ("TAIS") shall not be li abl e f or damages of any kind for use of thi s information, which is subject to
change without notice. Copyright 1994 TAIS. 5100.DOC Rev. 1 06/02/94 MQC/nmm.
Page 5
Loading...