Toshiba TDP T3 User Manual
Specifications and Main Features
- Model: PROSEC T3
- User program capacity: 31 500 steps maximum
- I/O Volume: 256 maximum for both
- Communication Interfaces: several, this depends on the used modules
- Voltage Supply: Special module for T3
- Temperature range of operation: Not lower than negative 10 degrees to 40 degrees
- Maximum Relative Humidity of Operation: 90%
- Weight: Will vary depending on the structure (not provided)
- Dimensions: Not specified
- Supported Languages: Ladder Diagrams, SFC, GRAFCET
- Input Registers: XW000 - XW255 (for batch input)
- Output Registers: YW000 - YW255 (for batch output)
- Direct Input Register: IW000 - IW255
- Direct Output Register: OW000 - OW255
- Auxiliary Register: RW600 - RW511
- Timer Register: T000 - T511
- Counter Register: C000 - C511
- Data Register: D0000 - D8191
- Special Function Registers: Various based on user needs
- Loss of Power Detection Feature: Yes
- Auxiliary Function: Appropriate self diagnostic parameters
- Errors and Malfunctions: Function of Reset Error
- Control of User Scaling Program Execution: It is possible to use three types non programmable of main sub and Interrupt
- I/O Configuration: Configuration of I/O function by “Replacing” Mode and service automatic input/output.
Frequently Asked Questions
Q: T3 User Program Capacity for the T3?
A: The T3 user program capacity for maximum is 31 500 steps.
Q: Thik Qe Kinda De Programming Languages Does The T3 Support?
A: The T3 Supports Ladder Diagram And Sequential Function Chart Sfc T3 Irb 1600-Sfc.
Q: What's The Operating Temperature Level For The T3 In Use?
A: Scale for operational T3 is set in a range of 0 to 55 degrees Celsius.
Q: In The T3 How Can I Allocate I/O Registers?
A: I O Registers Can Be Allocated Automatically Or Manually While The T3 Is In Haltt3 Ibr.
Q: What Happens During A Power Interruption?
A: Detection Of Power Interruption Is Incorporated In T3 Which Also Provides Different Recovery Options Including Automatic Programs After Restoration Of Power.
Q: Should The T3 Have Some Diagnotic Capabilities, At Least, What Are They?
A: Yes T3 Is Equipped With A Self-Diagnosis Capability So It Will Be Able To Exist A Self Checking.
Q: Now Let's Say My User Program Things That I Want To Do, Can The User Program Be Modified While It Is In Use?
A: The Program While Running Can Be Changed By Using The Online Program Changing Function.
Q: Finally Upon Powering Up The T3 How Is Data Initialized?
A: Upon Powering On Data Are Initialized As Per Preset Conditions Some Registers Are Barely Cleared Or Set As Is Depending On Users Configuration.
User Manual
Loading...