现货库存、技术资料、百科信息、热点资讯，精彩尽在鼎好!
TOSHIBA CMOS Digital Integrated Circuit Silicon Monolithic
TC7SH126FS
Bus Buffer with 3-STATE Output
Features
• High speed: tpd = 3.8 ns (typ.) at VCC = 5 V, 15pF
• Low power dissipation: I
• High noise immunity: V
• Wide operating voltage range: VCC (opr.) = 2~5.5 V
• 5.5-V tolerant input
Marking Pin Assignment (top view)
= 2 μA (max) at Ta = 25°C
CC
= V
NIH
= 28% VCC (min)
NIL
Weight: 0.001 g (typ.)
TC7SH126FS
SON5-P-0.35
(fSV)
H X
Product name
IN A
1
5
V
CC
2
GND
G
3
4
OUT Y
Absolute Maximum Ratings
Characteristics Symbol Rating Unit
Supply voltage range V
DC input voltage V
DC output voltage V
Input diode current I
Output diode current I
DC output current I
DC VCC/ground current ICC ±50 mA
Power dissipation PD 50 mW
Storage temperature T
(Ta = 25°C)
CC
IN
OUT
IK
OK
OUT
stg
−0.5~7 V
−0.5~7 V
−0.5~VCC + 0.5 V
−20 mA
±20 mA
±25 mA
−65~150 °C
Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the
significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even
if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum
ratings and the operating ranges.
Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook
(“Handling Precautions”/“Derating Concept and Methods”) and individual reliability data (i.e. reliability test
report and estimated failure rate, etc).
1
2007-11-01
IEC Logic Symbol Truth Table
TC7SH126FS
G
IN A
EN
OUT Y
G A Y
L X Z
H L L
H H H
Operating Ranges
Characteristics Symbol Rating Unit
Supply voltage VCC 2.0~5.5 V
Input voltage VIN 0~5.5
Output voltage V
Operating temperature T
Input rise and fall time dt/dv
0~V
OUT
opr
0~100 (VCC = 3.3 V ± 0.3 V)
0~20 (V
CC
−40~85 °C
= 5 V ± 0.5 V)
CC
V
V
ns/V
2
2007-11-01
Electrical Characteristics
DC Characteristics
TC7SH126FS
Characteristics Symbol Test Condition
High-level
input voltage
Low-level
input voltage
High-level
output voltage
Low-level
output voltage
3-state output
off-state current
Input leakage
current
Quiescent
supply current
V
V
V
IH
V
IL
V
= V
IN
OH
V
= V
IN
I
I
I
CC
OL
OZ
IN
or
V
= VIH or V
IN
V
OUT
VIN = 5.5 V or GND 0~5.5 ⎯ ⎯ ±0.1 ⎯ ±1.0 μA
VIN = VCC or GND 5.5 ⎯ ⎯ 2.0 ⎯ 20 μA
IOH = −50 μA
IH
IOH = −4 mA 3.0 2.58 ⎯ ⎯ 2.48 ⎯
I
IOL = 50 μA
IH
VIL
IOL = 4 mA 3.0 ⎯ ⎯ 0.36 ⎯ 0.44
I
= VCC or GND
Ta = 25°C Ta = −40~85°C
(V)
V
CC
2.0 1.5 ⎯ ⎯ 1.5 ⎯
⎯
⎯
= −8 mA 4.5 3.94 ⎯ ⎯ 3.80 ⎯
OH
= 8 mA 4.5 ⎯ ⎯ 0.36 ⎯ 0.44
OL
IL
3.0~5.5
2.0 ⎯ ⎯ 0.5 ⎯ 0.5
3.0~5.5 ⎯ ⎯
2.0 1.9 2.0 ⎯ 1.9 ⎯
3.0 2.9 3.0 ⎯ 2.9 ⎯
4.5 4.4 4.5 ⎯ 4.4 ⎯
2.0 ⎯ 0 0.1 ⎯ 0.1
3.0 ⎯ 0 0.1 ⎯ 0.1
4.5 ⎯ 0 0.1 ⎯ 0.1
5.5 ⎯ ⎯ ±0.25
Min Typ. Max Min Max
V
CC
0.7
×
⎯ ⎯
V
CC
0.3
VCC ×
0.7
×
⎯
⎯ ±2.5 μA
⎯
VCC ×
0.3
Unit
V
V
V
V
3
2007-11-01
TC7SH126FS
AC Characteristics
Characteristics Symbol
Propagation delay
time
3-state output
enable time
3-state output
disable time
Input capacitance CIN ⎯ ⎯ 4 10 ⎯ 10 pF
Output
capacitance
Power dissipation
capacitance
(Input: tr = tf = 3 ns)
Test Condition Ta = 25°C Ta = −40~85°C
V
t
pLH
t
pHL
t
pZL
t
pZH
t
pLZ
t
pHZ
⎯ ⎯ 6 ⎯ ⎯ ⎯ pF
C
OUT
(Note) ⎯ 15 ⎯ ⎯ ⎯ pF
C
PD
⎯
⎯
⎯
(V) CL (pF) Min Typ. Max Min Max
CC
3.3 ± 0.3
5.0 ± 0.5
3.3 ± 0.3
5.0 ± 0.5
3.3 ± 0.3 50 ⎯ 9.5 13.2 1.0 15.0
5.0 ± 0.5 50 ⎯ 6.1 8.8 1.0 10.0
15 ⎯ 5.6 8.0 1.0 9.5
50 ⎯ 8.1 11.5 1.0 13.0
15 ⎯ 3.8 5.5 1.0 6.5
50 ⎯ 5.3 7.5 1.0 8.5
15 ⎯ 5.4 8.0 1.0 9.5
50 ⎯ 7.9 11.5 1.0 13.0
15 ⎯ 3.6 5.1 1.0 6.0
50 ⎯ 5.1 7.1 1.0 8.0
Unit
ns
ns
ns
Note: CPD is defined as the value of the internal equivalent capacitance which is calculated from the operating
current consumption without load.
Average operating current can be obtained by the equation:
I
CC (opr.)
= CPD･VCC･fIN + ICC
4
2007-11-01
Package Dimensions
TC7SH126FS
Weight: 0.001 g (typ.)
5
2007-11-01
TC7SH126FS
RESTRICTIONS ON PRODUCT USE
• The information contained herein is subject to change without notice.
• TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor
devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical
stress. It is the responsibility of the buyer, when utilizing TOSHIBA products, to comply with the standards of
safety in making a safe design for the entire system, and to avoid situations in which a malfunction or failure of
such TOSHIBA products could cause loss of human life, bodily injury or damage to property.
In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as
set forth in the most recent TOSHIBA products specifications. Also, please keep in mind the precautions and
conditions set forth in the “Handling Guide for Semiconductor Devices,” or “TOSHIBA Semiconductor Reliability
Handbook” etc.
• The TOSHIBA products listed in this document are intended for usage in general electronics applications
(computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances,
etc.).These TOSHIBA products are neither intended nor warranted for usage in equipment that requires
extraordinarily high quality and/or reliability or a malfunction or failure of which may cause loss of human life or
bodily injury (“Unintended Usage”). Unintended Usage include atomic energy control instruments, airplane or
spaceship instruments, transportation instruments, traffic signal instruments, combustion control instruments,
medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA products listed in his
document shall be made at the customer’s own risk.
• The products described in this document shall not be used or embedded to any downstream products of which
manufacture, use and/or sale are prohibited under any applicable laws and regulations.
• The information contained herein is presented only as a guide for the applications of our products. No
responsibility is assumed by TOSHIBA for any infringements of patents or other rights of the third parties which
may result from its use. No license is granted by implication or otherwise under any patents or other rights of
TOSHIBA or the third parties.
20070701-EN GENERAL
• Please contact your sales representative for product-by-product details in this document regarding RoHS
compatibility. Please use these products in this document in compliance with all applicable laws and regulations
that regulate the inclusion or use of controlled substances. Toshiba assumes no liability for damage or losses
occurring as a result of noncompliance with applicable laws and regulations.
6
2007-11-01
Loading...