Toshiba sfb9001 Service Note
Publish Date: 99/11/09
.
.
BSI No.: SFB9001
Subject:
Changing the Service Manual (SVC INSTALL)
Model: TF610
Category Field Application Unit
Modification/Correction of Service
Manual
Factory Application:
To be applied immediately Operator's Manual/Service Manual
CONTENT
1. Document No.
For TABS
For except TABS E0-26150
2. Reason for Change
To correct the type of data to be initialized by Service Installation Clear.
E0-26146
.
.
.
.
Page 3-31 8. Memory Clear
Steps (5) and (6) are added.
Page 11-10 1.2.9 Service Installation Clear
"Country setting" and "Margin adjustment" are added as the data to be initialized by this procedure.
"Heater adjustment" is deleted.
Attached Files
SFB9001.pdf
7. Country Setting
At the time of installation, be sure to perform the country setting for each country .
Procedure:
(1) Select the dial key number from the tab le below . (The ROM type can be confirmed by the ROM
version No.)
(2) T u rn the power on while pressing and holding the dial key selected in (1) and the [STAR T] key at
the same time.
(3) Confirm that the country name (example: US) displayed on the LCD is correct.
Key 0123456789*#
ROM type
EU PT DE GB CH NL BE AT SE NO DK FI IT
US US CA AU SG HK TW
FR FR
TF610
ES PT DE GB CH NL BE AT SE NO DK ES IT
NOTE: The country setting should always be performed when the ROM or Main PBA is
replaced.
8. Memory Clear
At the time of installation, be sure to perform a full memory clear to initialize the machine before
entering the function setup procedures. After the memory clear , go on to whate ver prog ramming procedures that are necessary.
Procedure:
(1) Press the [1], [3], and [8] keys at the same time in the standby status.
(2) Enter the 4-digit password "5656", then pressing the [START] key.
(3) Select the "INDIVIDUAL TEST" by using the [MENU/ ↑ ] key then pressing the [ENTER] key.
(4) Select the "SVC INSTALL" by using the [MENU/ ↑ ] or [ ↓ ] key then pressing the [START]
key. (Ref er to Chapter 11: 1.2.9, "Service Installation Clear" page 11-10.)
(5) Perform the country setting. (Refer to Chapter 3: 7, "Country Setting."
(6) Perf orm the margin setting. (Refer to Chapter 11: 1.2.14, "Margin Settings.")
SERVICE MANUAL 3-31 Chapter 3
Loading...