Toshiba HDD1364 User Manual

Page 1
TOSHIBA AMERICA INFORMATION SYSTEMS STORAGE DEVICE DIVISION IRVINE, CALIFORNIA
MK2003GAH (HDD1364)
1.8-INCH HARD DISK DRIVE USER MANUAL
Rev 02
11/2006
Page 2
CONTENTS
Introduction..............................................................................1
Setup ........................................................................................2
Using the HDD .........................................................................3
Specifications ..........................................................................4
Drive Connectors..................................................................... 6
Page 3
INTRODUCTION – MK2003GAH (HDD1364) HARD DISK DRIVE
General Features
1.8" sized drive
2 Platter
20 Gigabytes*
8mm High
15ms Average Seek Time
ATA (2 - 5) Interface
Ultra DMA 100
512KB Buffer
Rotational speed of 4,200rpm
MTTF 300,000 Hours
*Toshiba defines a megabyte (MB) as 1,000,000 bytes and a gigabyte (GB) as 1,000,000,000 bytes.
1
Page 4
SETUP – MK2003GAH (HDD1364) HARD DISK DRIVE
Caution: Your Hard Disk Drive is a precision device and even a small drop onto any surface can cause damage. Electronstatic discharge can also damage the drive. You should ground yourself prior to handling the drive.
Figure 1. MK2003GAH Side View
Installation Notes
Do not apply any force to the top cover, except the screw areas on top cover. Maximum force to the
specified area is 2N.
important Note: Disconnect power from your computer system before beginning installation
2
Page 5
USING THE HARD DISK DRIVE – MK2003GAH (HDD1364) HARD DISK DRIVE
Backing up Data Files
To avoid data loss, regularly back up the data files on the hard disk drive.
3
Page 6
SPECIFICATIONS –MK2003GAH (HDD1364) HARD DISK DRIVE
General
Model MK2003GAH (HDD1364) Interface ATA-2/3/4/5
Functionality
Formatted Capacity 20.0GB* Rotational Speed 4200rpm Avg. Rotational Latency 7.14/ms Spin-up Time 3.5sec (typical) Buffer 512KB Seek Time Average Maximum
15
26 Internal Transfer Rate 115.6 ~ 204.4 Mbits/sec (max) Host Transfer Rate Ultra DMA mode PIO Mode
100Mbytes/sec
16.6Mbytes/sec
Interleave Factor 1:1
*Toshiba defines a megabyte (MB) as 1,000,000 bytes and a gigabyte (GB) as 1,000,000,000 bytes.
Internal Drive Characteristics
Number of Disks 2 Number of Data Heads 4 Track Density (TPI) 2237 (56.8k)
Logical Cylinders 16,383 Logical Heads 16 Logical Sectors/track 63 Bytes per Sector 512 Logical Blocks (LBA) 39,062,520
Reliability
Preventative maintenance None Non-recoverable read errors 1 error per 10
Electrical
Voltage 3.3V 5%
Power Consumption
Start 1.3W typ Seek 1.4W typ Read/Write 1.4W typ Sleep 0.08W typ Energy Consumption Efficiency 0.02W/GB avg
Shock Operating 1,960m/s
Non-Operating 9,800m/s2 (1000G)(1msec)
4
13
bits read
2
(200G)(2msec)
Page 7
Physical
Height 0.315 (8.0mm) Width 2.13" (54.0mm) Depth 3.09" (78.5mm) Weight 2.19oz (62g) typ
Regulatory
The drive satisfies the following standards: Underwriters Laboratories (UL) 1950 Canadian Standard Association (CSA) C22.2 No. 950 TUV Rheinland EN 60 950 EMC - EN50081-1 EN50081-1: 1992
EN55022: 1994 Class B EN61000-3-2: 1995 EN61000-3-3: 1995
EMC - EN50082-1 EN61000-4-2: 1995
EN61000-4-3: 1998 ENV50204: 1995 EN61000-4-4: 1995 EN61000-4-5: 1995 EN61000-4-6: 1996 EN61000-4-11: 1994
BSMI
3902C799
5
Page 8
DRIVE CONNECTORS –MK2003GAH (HDD1364) HARD DISK DRIVE
Figure 1. MK2003GAH HDD - INTERFACE CONNECTOR
Interface Connector
Drive Side Connector MCD-D50 Series by Recommended Host Side Connector MCD-D50 Series by DDK Connectors
DDK Connectors
6
Page 9
Interface Signals
DRIVE INTERFACE SIGNALS
PIN SIGNAL PIN SIGNAL
1 RESET 2 GROUND
3 DD 7 4 DD 8
5 DD 6 6 DD 9
7 DD 5 8 DD 10
9 DD 4 10 DD 11
11 DD 3 12 DD 12
13 DD 2 14 DD 13
15 DD 1 16 DD 14
17 DD 0 18 DD 15
19 GROUND 20 OPEN
21 DMARQ 22 GROUND
23 DIOW/STOP 24 GROUND
25
27
29 DMACK 30 GROUND
31 INTRQ 32 IOCS16
33 DA1 34 PDIAG
35 DA0 36 DA 2
37 CS0 38 CS1
39 DASP 40 GROUND
41 3.3V (LOGIC) 42 3.3V (MOTOR)
43 GROUND 44 RESERVED
DIOR/
-DMARDY
HSTROBE
IORDY/
-DMARDY/­DSTROBE
26 GROUND
28 CSEL
Note: Symbol () in front of signal indicates negative logic.
7
Loading...