Toshiba G00F044 Service Note

BSINo. G00F044 Page 1

BSI No.: G00F044 Publish

2000/06/06

Date: Subject: Correction of Errors in the SC-2 Hardware Service Manual

Model: SC-2

Category Field Application UNIT

Correction of Service Manual Others Network Function, Documents

FactoryApplication: -

CONTENT

Some errors have been found in the SC-2 Hardware Service Manual, which have been corrected as shown in the following table.

Page

‡Y

Table 2-3 System Board ........

9 1.3.4.1 SCSI Cable Installation

1.Align the connector of SCSI interface cable with the port on the

back of the controller.

Before Change After Change

Press inward the spring clips and gently, but firmly, press the connector onto the SCSI port. Release the spring clips.

------ Deletion

1.Align the connector of SCSI interface cable with the port on the

back of the controller.

Gently, but firmly, press the connector onto the SCSI port and using a small, flat blade screwdriver, tighten the screws on either side of the

Remarks

connector.

2.Align the another connector of the SCSI interface cable with the SCSI

port on the back of the copier.

Press inward the spring clips and gently, but firmly, press the connector onto the SCSI port. Release the spring clips.

2.Align the another connector of the SCSI interface cable with the SCSI

port on the back of the copier.

Gently, but firmly, press the connector onto the SCSI port and using a small, flat blade screwdriver, tighten the screws on either side of the connector.

17 Nil

21~22 2.3.3 Memory

The system

49 3.7.2 Installing HDD

7.Make sure that the CMOS

........

Deletion from "The system board" to "Table 2-3"

N/A 5 points

corrected in the table.

------ "7" deleted

setting is correct for the replaced HDD. Refer to the HDD's label for CMOS information.

57 3.11 DIMMs

Note: The equipped memory is installed in

the Bank in order

Attached File

. Install additional memory

to through 3.