Toshiba G00D998 Service Note
BSINo. G00D998 Page 1
BSI No.: G00D998
Publish
2000/04/26
Date:
Subject: Change of Stacker ROM
Model: MJ1006, MJ1007
Category Field Application UNIT
Countermeasure to field trouble Others Finisher
FactoryApplication: From Mar. 2000 at the factory
CONTENT
The following changes have been made as part of the countermeasure to be explained later.
[Changed/Added Part No.]
P-I Before Change After Change Note P I R
27-2
P-I: Page-Item P: Content of Change I: Interchangeability R: Reason for Change
[Label]
[Changed Contents]
z
4402354600
PRA-793FIN-07
4F1-1501 O
1.2.3.4.5.6.
7.8.9.10.20.
Control to improve the bin movement time
The current tray movement time is across the board 17sec. regardless of the presence or
absence of a paper on the tray. The following changes have been now made.
Tray movement origin
1 bin 2 bin
1 bin (Paper on the tray exist) 2 bin
1 bin 2 bin (Paper on the tray exist)
1 bin (Paper on the tray exist) 2 bin (Paper on the tray exist)
2 bin 1 bin
2 bin (Paper on the tray exist) 1 bin
2 bin 1 bin (Paper on the tray exist)
2 bin (Paper on the tray exist) 1 bin (Paper on the tray exist)
4402354610
PRA-793FIN-08
4F1-1501 O
1.2.3.4.5.6.
7.8.9.10.20.
Tray movement destination Movement
---- C B J -
Time
Almost 12 sec.
Almost 8 sec.
Almost 17 sec.
FAA
Before the alignment plate returns, the alignment of the next sheet starts.
z
As a countermeasure to this error, in the staple mode the first LD sheet and the second LT sheet,
after the alignment of the first sheet but before the complete returning of the alignment plate, the
second sheet is completely discharged. From that position (the paper has run on to the alignment
plate), the alignment treatment starts and the fault has been corrected.
z
In the case of staple loading in the LT -> LD order, an improvement of the alignability at LT has
been made.
BSINo. G00D998 Page 2
When LT is aligned on the staple tray, just before the next sheet (CD) is discharged, the alignment
plate presses against the paper. Then it is not pulled back by the knurling belt and skewing as well
as other errors can arise. This problem has now been corrected.
Attached File
Related Documents:
LinkTo: Link From:
Loading...