Toshiba G00D010 Service Note

BSINo. G00D010 Page 1

BSI No.: G00D010 Publish

2000/04/21

Date: Subject: Addition of Sliding Mylar to ADU Driving Area (DRV-ADU)

Model: DP4580, DP5570, DP6570, DP8070

Category Field Application UNIT

Treatment in the field, Change of

Parts

FactoryApplication:

LC015194 ~ ND016553 ~ ZD011712 ~ RD010001 ~(DP8070: from 1st lot)

Others ADD/ADU

CONTENT

In order to prevent rust caused by contact between SPC200-100-350 (SPL P.21-I.30 4406342760 ) and K-BKT-DRIVE-ADU (SPL P.21-I.26 4406342700), a sliding mylar has been added.

P-I Before Change Q'ty Note P I R

21-7 4406345190

Translucent

A - J -

MAYLAR-DRV-ADU

P-I: Page-Item P: Content of Change I: Interchangeability R: Reason for Change

SPC200-100-350

MYLAR-DRV-ADU

(Addition)

K-BKT-DRIVE-ADU

Addition Method (Simplified Method)

FAA

(1) Clean the rust, oil and dirt from the face.

Make a notch in

(2) (See the figure on the right) (3) Peel off the protective sheet of double-sided tape.

(4) Pick up SPC200-100-350 by hand. (See the figure on the right)

(5) Fix (See the figure on the right)

MAYLAR-DRV-ADU

MAYLAR-DRV-ADU.

to the shaft.

BSINo. G00D010 Page 2

Cut

(6) Attach circumference. (See right figure)

MAYLAR-DRV-ADU

along the bearing outer

Note

* The sticking can be corrected 2 or 3 times with no problem. * Check that the sliding mylar does not overlap.

Attached File